User manual PHILIPS FW-P880

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] ­ When the CD has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed. Note: ­ Pressingí during shuffling can only skip to the beginning of the current track. Searching for a particular passage during playback · Press and hold à or á until the desired passage is located. · Play returns to normal when à or á is released. Selecting a desired track Selecting a desired track when playback is stopped 1 Press í or ë (or Digit 0-9 on the remote control) until the desired track appears on the display. Å TM The selected track number and elapsed playing time appear on the display. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. pg 01-31/P88/22-Eng 18 3/6/00, 1:26 PM 3139 116 19721 CD ­ If the system is reading the disc, programming is not possible, "READING" will be displayed and followed by "DISC X" . "X" is the current read disc number. ­ During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically. Notes: ­ If you press any of the CD DIRECT PLAY buttons, the system will play the selected disc or track and the stored program will be ignored temporarily. The PROGRAM display also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. ­ REPEAT DISC mode is not available when program playback begins. In shuffle mode, the system plays all the available discs and their tracks in random order. Shuffle may be used also when tracks are programmed. To shuffle all the discs and tracks 1 Press SHUFFLE. TM "TRACK" or "PROGRAM" will be displayed. TM The REPEAT and PROGRAM appear on the display. 2 Press Ç to stop program playback. Notes: ­ REPEAT DISC mode is not available during program play or shuffle mode. ­ You can also repeat shuffling a program. TM "TRACK" or "PROGRAM" will be displayed. TM The REPEAT, PROGRAM and SHUFFLE appear on the display. Note: ­ REPEAT DISC mode is not available when shuffle is selected. pg 01-31/P88/22-Eng 19 3/6/00, 1:26 PM 3139 116 19721 TUNER MINI HIFI SYSTEM STANDBY ON LEFT CENTER RIGHT DOLBY B NR SURR SURR NEWS/TA POWER SAVE PRO LOGIC RDS IR SENSOR CD 1·2·3 C1 · 2 · 3 CD VEC BASS/ T RE BAND BAND TUNER STOP·CLEAR TAPE 1·2 TAPE PLAY PAUSE v CDR/DVD CDR AUX PRESET v PREV SIDE NEXT CD TEXT BL SEARCH·TUNING E VOLUME PERSON AL DS C PROG CLOCK/ TIMER DIM A. REV DUB (HSD) RECORD BASS TREBLE PLUS wOOx TECHNOLOGY LEVEL TM The system will start searching for all radio stations with RDS and then followed by radio stations on FM, MW and LW band respectively. TM All available stations will be stored automatically. The frequency and preset number will be displayed briefly. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. TM The system will remain tuned to the last stored preset radio station. 4 Press à or á to tune to the desired frequency. [. . . ] · Magnetic build-up in the record/ playback head. · Power failure or AC power plug disconnect from the wall outlet during tape playback. TM Reconnect the AC power plug and switch on the system again. · Tape was recorded in one of the Dolby Pro Logic modes. [. . . ]