User manual PHILIPS FW326

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). ¶ As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: ­ Connect the blue wire to the terminal marked N or coloured black. Connect the brown wire to the terminal marked L or coloured red. [. . . ] To listen through the headphones q Connect the headphones plug to the n socket at the front of the system. DSC (Digital Sound Control) The DSC feature enables you to enjoy special sound effects that have preset equaliser settings, providing the best music reproduction. Note: ­ Some discs or tapes might be recorded in high modulation, which causes a distortion at high volume. If this occurs, switch off DBB or reduce the volume. automatic DSC-DBB selection The best DBB setting is generated automatically for each DSC selection. You can manually select the DBB setting that best suits your listening environment. DIM mode Brightness normal half half normal Spectrum Analyser off on off on Therefore, do not use any accessories such as disc stabiliser rings or disc treatment sheets, etc. , as offered on the market, because they may jam the changer mechanism. ­ Do not load more than one disc into each tray. This system can playback all digital audio CD, finalised digital audio CD-Recordable (CDR) discs and finalised digital audio CD-Rewritable (CDRW)discs. The selected disc tray, total number of tracks and the playing time will appear on the display. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. The total number of tracks programmed and the total playing time are displayed. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "FULL" is displayed. ­ If you press any of the CD DIRECT 1/2/3 buttons on the remote control, the system will play the selected disc or track, and the stored programme will be ignored temporarily. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. Press and hold à or á until the frequency indication starts to change, then release. The display will show "SEARCH" until a radio station with sufficient signal strength is found. Repeat step 3 if necessary until you find the desired radio station. Q To tune to a weak station, press à or á briefly and repeatedly until optimal reception found. To begin automatic preset from a desired preset number q Press í or ë to select the desired preset number. [. . . ] Q You can programme the tracks in the order you want them to be recorded (refer to "CD Operation - Programming the disc tracks"). ­ Recording is permissible if copyright or other rights of third parties are not infringed upon. ­ To ensure good dubbing, use tapes of the same length. Q Make sure both tapes have their full spool to the left. [. . . ]