User manual PHILIPS FW356C

[. . . ] 5 Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 7 Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 - 11 CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 - 14 Aux . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] TM The PROG flag starts flashing and "AUTO" will be displayed. TM The system will search for every available station in the FM waveband first, then search the MW waveband. TM All available stations will be stored automatically. The frequency and preset number will be displayed briefly. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. TM The system will remain tuned to the last stored preset radio station. OPTIMAL TUNING PRESET DB B JAZZ SEARCH ROCK STOP· CLEAR PLAY· PAUSE PREV CLOCK·TIMER DIM NEXT PROGRAM TECHNO MICROPHONE - LEVEL VOLUME SOUND NAVIGATION - JOG Note: ­ For 'EASY SET' feature, please refer to page 10. Tuning to radio stations 1 Press TUNER (BAND) to select TUNER mode. A few seconds later, the current radio frequency will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM or MW. 3 Press à or á for more than one second, then release. TM The display will show "SEARCH" until a radio station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. · To tune to a weak station, briefly press à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained. Manual programming 1 Press TUNER (BAND). TM The tape will stop automatically at the end of rewinding or fast forwarding. 2 Press STOP·OPEN to stop rewinding or fast forwarding. DB B TECHNO MICROPHONE - LEVEL VOLUME SOUND NAVIGATION - JOG Continuous Playback From Tape Deck 2 to Tape Deck 1 TAPE 2 TAPE 1 4 Close the tape deck door. Tape Playback 1 Press TAPE to select TAPE mode. 2 Load the tape into the selected tape deck. · To interrupt playback, press PAUSE. · To resume playback, press PAUSE again. 4 Press STOP·OPEN to end playback. 1 2 3 4 5 FULL AUTO STOP RECORD PLAY STOP. OPEN PAUSE PLAY STOP. OPEN PAUSE Press TAPE to select TAPE mode. TM Playback will begin with tape deck 2 and will continue with tape deck 1 when playback on tape deck 2 ends. 6 Press STOP·OPEN if you want to stop playback before the end of the tape in tape deck 1 or tape deck 2. v v v v 17 pg 01-24/C30/21&/30-En 17 3/3/00, 4:23 PM 3139 116 19351 English Loading a tape Rewind/Fast Forward v v v v v v v TAPE Notes: ­ During rewinding or fast forwarding of a tape, it is also possible to listen to another source (e. g. ­ Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism. ­ C-120 tape is extremely thin and is easily deformed or damaged. [. . . ] TM Switch to the correct tuning grid. 23 pg 01-24/C30/21&/30-En 23 3/3/00, 4:23 PM 3139 116 19351 English TROUBLESHOOTING Tape Deck Operation "RECORDING ACTIVE" is displayed. TM Stop the recording or wait until it is finished. Recording or playback cannot be made or there is a decrease in audio level. · Dirty tape heads, capstans or pressure rollers. [. . . ]