User manual PHILIPS FW36

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] Å To stop playback Press Ç. DISC CHANGE OPEN·CLOSE DISC 1 DISC 2 DISC 3 3 CD CHANGER VOLUME DEMO CLOCK. TIMER CD 2 TAPE RECORD TIMER SET DUBBING BAND SHUFFLE TIMER 1 2 3 SHUFFLE FMMW SW LW STEREO NR RECORD PROGRAM FRONT DBB BACK HSD AMPM PLAY MODE PROGRAM TIMER SET CLOCK 1 SIDE RDS MODE CLEAR PRESET TUNING 3 Press OPEN/CLOSE to close the disc tray. The selected disc tray, total number of tracks and the playing time will appear on the display. For MP3 disc, the name of the first album will be scrolled through the display once and followed by "AXX TXXX". Notes: ­ Load the discs with the label side facing up. ­ For MP3 disc, the disc reading time may exceed 10 seconds due to the large number of songs compiled into one disc. 1 2 Replacing discs during playback 1 2 Press DISC CHANGE. The disc tray will open without interrupting current playback. To change the inner disc, press DISC CHANGE again. "DISC CHANGE" is displayed and the disc will stop playing. The disc tray will close to retrieve the inner disc, then reopen with the inner disc accessible. 16 CD/MP3-CD Operations Selecting a desired track/passage To search for a particular passage during playback Repeat play You can select and change the various play modes before or during playback. 1 Press à or á until the desired passage is located. To select a desired track 1 Press í or ë repeatedly until the desired track is displayed. If playback is stopped, pressÉ to start Å playback. Press REPEAT on the remote control repeatedly to select : "TRACK" ­ to repeat playback of the current track. The total number of tracks programmed and the total playing time are displayed. For MP3 disc, total playing time will not be shown. To start programme play, pressÉ . Å "PLAY PROGRAM" is displayed. Notes: ­ It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks. ­ If the total playing time is more than "99:59" then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 99 tracks, "FULL" is displayed. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. To review the programme Stop playback and pressí or ë repeatedly. To exit review mode, press Ç. 8 For Recording, please refer to "Tape Operation/Recording". 18 Radio Reception English CD1 CD2 CD3 Tuning to radio stations 1 Press TUNER to select TUNER mode. A few seconds later, the current radio frequency will appear on the display. [. . . ] To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. Cleaning the Heads and the Tape Paths To ensure good recording and playback quality, clean the heads A and B, the capstan(s) C, and pressure roller(s) D after every 50 hours of tape operation. Use a cotton swab slightly moistened with cleaning fluid or alcohol. [. . . ]