User manual PHILIPS FW375P

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] A few seconds later, the current frequency will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press TUNING à or á for more than one second, then release. TM The display will show `SEARCH' until a radio station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. · To tune to a weak station, briefly press TUNING à or á until the display shows the desired frequency and/or when the best reception has been obtained. 6/15/00, 3:34 PM 3139 116 18652 TUNER You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press PROGRAM for more than one second. TM PROGRAM flag starts flashing and `AUTO' will be displayed. TM Every available station for the selected waveband will be stored automatically. · RADIO TEXT (RT): text messages appear in the display. Note: ­ When you press the RDS button and the display shows "NO RDS", it indicates that either the tuned station is not transmitting RDS signal or it is a non RDS station. RDS Time Some RDS station may be transmitting a real time clock at an interval of every minute. Setting the time with RDS clock 1 Press CLOCK/TIMER. TM "--:--" or current time appears on the display. 2 Press CLOCK/TIMER once more to enter clock setting mode. TM "00:00" or current time starts flashing. TM The message "SEARCH RDS TIME" will be displayed. Notes: ­ You can cancel the automatic programming by pressing PROGRAM or STOP·CLEAR Ç on the system only. Notes: ­ When 40 radio stations are stored and you attempt to store another radio station, the display will show " PROGRAM FULL". If you want to change an existing preset number; repeat steps 4 and 5. Untitled-12 15 6/15/00, 3:34 PM 3139 116 18652 TUNER TM If the station does not transmit RDS clock, "NO RDS TIME" will be displayed. TM When the RDS clock is read, "RDS TIME" will be displayed. The current clock time is displayed for 2 seconds and will be stored automatically. · When News transmission is detected, the system will switch to Tuner mode. · After News has ended, the last selected source mode will be resumed. [. . . ] TM Stop the recording or wait until it is finished. "TAPE DUBBING ONLY" is displayed. · Tape dubbing is only possible in tape mode. Recording or playback cannot be made or there is a decrease in audio level. [. . . ]