User manual PHILIPS FW390C

[. . . ] Mini HiFi System FW390C 1 Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] TM PROGRAM flag starts flashing and `AUTO' will be displayed. TM Every available station for the selected waveband will be stored automatically. The frequency and preset number will be displayed briefly. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. TM The system will remain tuned to the last stored preset radio station. · Repeat the above procedure to store other preset radio stations for the other waveband. Remember to select the next available preset number before proceeding. If not, some of the preset radio stations may be erased. English 15 Storing Preset Stations ­ If you want to reserve a section of preset numbers, for example preset numbers 1 to 9, select preset 10 before starting automatic programming: now only the preset numbers 10 to 40 will be programmed. Manual programming 1 Press TUNER. 2 Press TUNER (BAND) to select the desired waveband : FM, MW or LW. 3 Press PROGRAM for less than one second. TM PROGRAM flag, the frequency and preset number start flashing. TM The next available preset number will be displayed for selection. 4 Press TUNING à or á to tune to the desired frequency. · If you wish to store the radio station to another preset number, press PRESET 4 or 3 to select the desired preset number. TM PROGRAM flag will stop flashing, and the radio station will be stored. · Repeat the above procedure to store other preset radio stations. ­ You can cancel manual programming by pressing STOP·CLEAR Ç on the system only. ­ During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically. When you have tuned to a RDS station, the RDS logo (Ç) and the station name will appear on the display: · The display normally shows the radio station name if available. By repeatedly pressing RDS button you can change the type of display information: TM The display shows in turn: STATION NAME TM FREQUENCY TM PROGRAM TYPE TM RADIO TEXT TM STATION NAME . . . Tuning to Preset Radio Stations · Press PRESET 4 or 3 to select the desired preset number. TM The preset number, frequency and waveband appear on the display Receiving RDS radio station Ç RDS (Radio Data System) is a broadcasting service that allows FM stations to send additional information along with the regular FM radio signal. This additional information can contain: · STATION NAME: The station name is displayed. · FREQUENCY: The frequency of the station is displayed. [. . . ] Recording or playback cannot be made or there is a decrease in audio level. · Dirty tape heads, capstans or pressure rollers. TM See section on tape deck maintenance. · Magnetic build-up in the record/ playback head. [. . . ]