User manual PHILIPS FW540C

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] A few seconds later, the current radio frequency will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press TUNING à or á for more than one second, then release. TM The display will show "SEARCH" until a radio station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. · To tune to a weak radio station, briefly press TUNING à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained. Storing Preset Stations You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. Automatic programming 1 Press TUNER (BAND). 2 Press PROGRAM for more than one second. TM The PROGRAM flag starts flashing and "AUTO" will be displayed. 15 Untitled-13 15 6/15/00, 1:15 PM 3139 116 18533 English v TUNER TM The system will search for every available station in the FM waveband first, then search by the MW and LW wavebands. TM All available radio stations will be stored automatically. The frequency and preset number will be displayed briefly. ­ If you want to reserve a section of preset numbers, for example preset numbers 1 to 9, select preset 10 before starting automatic programming: only the preset numbers 10 to 40 will be programmed. Manual programming 1 Press TUNER (BAND). 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press PROGRAM for less than one second. TM The next available preset number will be displayed for selection. Notes: ­ When 40 radio stations are stored and you attempt to store another radio station, the display will show" FULL". If you want to change an existing preset number, repeat steps 3 ­ 5. ­ You can cancel manual programming by pressing STOP·CLEAR Ç (on the system only). ­ During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically. Tuning to Preset Radio Stations · Press PRESET 4 or 3 to select the desired preset number. TM The preset number, radio frequency, and waveband appear on the display. Untitled-13 16 6/15/00, 1:15 PM 3139 116 18533 TUNER News/TA (Traffic Announcement) (only available in Radio Station with RDS) You can activate NEWS or TA function in Standby, Demonstration or any source mode except Tuner mode. Once the News Program Type (for NEWS function) or Traffic Announcement data (for TA function) is detected in any of the selected RDS stations, it will switch to TUNER mode automatically. NEWS/TA key toggles in the following sequence : NEWS TM TA TM OFF TM NEWS To start NEWS or TA function 1 Press NEWS/TA to select NEWS function. TM The NEWS flag and "NEWS" will be displayed. · If you want to select TA function, press NEWS/TA again. [. . . ] TM Select another RDS station. Untitled-13 25 6/15/00, 1:16 PM 3139 116 18533 TROUBLESHOOTING Tape Deck Operation Recording or playback cannot be made or there is a decrease in audio level. · Dirty tape heads, capstans or pressure rollers. TM See section on tape deck maintenance. · Magnetic build-up in the record/ playback head. [. . . ]