User manual PHILIPS FW560C

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] · If you press REPEAT during shuffling, the current track will be played repeatedly. TM The REPEAT and SHUFFLE flags will be displayed. 2 Press SHUFFLE again to resume normal playback. TM The SHUFFLE flag disappears from the display. Note: ­ If you press any of the 3 CD DIRECT PLAY buttons, the system will play the selected disc or track and the stored program will be ignored temporarily. The PROGRAM flag will also temporarily disappear from the display and then reappear, when the playback for the selected disc ends. Reviewing the program Reviewing of the program is only possible in the stop mode. · Press PREVí or NEXTë repeatedly to review the programmed tracks. · Press STOPÇ to exit review mode. Note: ­ All the available discs will be played once, then stop. pg 001-27/FW775-765P/22-Eng 17 9/1/99, 9:37 AM TUNER EASY RADIO SET Press 'STANDBY- ON' for 2 seconds to set radio stations automatically STEREO HOME CINEMA CONTROL JAZZ CLASSIC ROCK TECHNO DIGITAL SOUND CONTROL DBB IS PHANTOM 3 STEREO LW HSD REC AM ­ If RDS station does not transmit RDS time within 90 seconds, the program will exit automatically and the display will show " NO RDS TIME" . TUNING CLEAR SIDE A · B Easy Set (only in Standby or Demonstration mode) EASY SET allows you to store all available radio stations and RDS stations in a particular band (FM·MW·LW) automatically. 1 Press and hold STANDBY·ON (on the system only) for 2 seconds. TM "EASY SET" will be displayed and followed by "TUNER". TM Easy set will start with the last active band. TM All available radio stations with sufficient signal strength will be stored or until 40 presets are filled. Remember to select the next available preset number before proceeding. If not, some of the preset radio stations may be erased. · Press PRESET 4 or 3 to select the desired preset number. TM The preset number, frequency and waveband appear on the display. English 19 Storing Preset Radio Stations Manual programming 1 Press TUNER. 2 Press TUNER (BAND) to select the desired waveband: FM, MW or LW. 3 Press PROGRAM for less than one second. TM PROGRAM flag, the frequency and preset station number start flashing. TM The next available preset number will be displayed for selection. 4 Press TUNING à or á to tune to the desired frequency. · When all 40 presets are stored, no preset number is shown. [. . . ] TM Check that the speakers are connected correctly. TM Make sure that the stripped speaker wire is clamped. · Speakers are incorrectly connected. TM Check the speaker connections and location. [. . . ]