User manual PHILIPS FW60

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] All the available discs or programmed tracks (if programme is active) will be played in random order. To resume normal playback, press SHUFFLE again. Notes: ­ During programme play or shuffling mode, it is not possible to repeat playback the current disc (Repeat Disc mode). ­ Pressing the OPEN/CLOSE button will cancel all repeat and shuffling modes. 2 Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "FULL" is displayed. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. To review the programme q Stop playback and pressí or ë repeatedly. q To exit review mode, press Ç. Erasing the programme q Press Ç once when playback is stopped or twice during playback. PROG disappears and "PROGRAM CLEARED" is displayed. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order. 1 2 3 4 5 6 Load the desired discs on the disc tray (refer to "Loading discs"). PROG disappears. Press and hold Çon the system until "PRESET DELETED" is displayed. The deleted radio frequency remains on the display. The preset numbers of all other preset radio stations in the band with higher numbers are also decreased by one. q Repeat steps 1­2 to erase other preset radio stations. q Repeat steps 1­3 to store other radio stations. To exit manual preset mode q Press Ç on the system. Notes: ­ If you attempt to store more than 40 preset radio stations, "FULL" is displayed. ­ During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically. For Recording, please refer to "Tape Operation/Recording". RDS RDS (Radio Data System) is a broadcasting service that allows FM stations to send additional information along with the regular FM radio signal. This additional information can contain: Station name: The radio station name is displayed. Programme type: The following programme types exist and can be received by your tuner: News, Affairs, Info, Sport, Educate, Drama, Culture, Science, Varied, Pop M, Rock M, M. O. R. (middle of the road music), Light M, Classics, Other M, No type. Radio text (RT): text messages appear on the display. [. . . ] q Use a cotton swab slightly moistened with cleaning fluid or alcohol. q You can also clean the heads by playing a cleaning tape once. CBAB C Demagnetising the heads q Use a demagnetising tape available at your dealer. Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. [. . . ]