User manual PHILIPS FW61

[. . . ] País de Origen: China Nº de Serie: ______________________________ Descripción: Modelo : Alimentación: Consumo: Importador: Domicilio: LEA CUIDADOSAMENTE ESTE INSTRUCTIVO ANTES DE USAR SU APARATO. AVISO IMPORTANTE Philips Mexicana, S. A. no se hace responsable por daños o desperfectos causados por: ­ Maltrato, descuido o mal uso, presencia de insectos o roedores (cucarachas, ratones etc. ). ­ Cuando el aparato no haya sido operarado de acuerdo con el instructivo del uso, fuera de los valores nominales y tolerancias de las tensiones (voltaje), frecuencia (ciclaje) de alimentación eléctrica y las características que deben reunir las instalaciones auxiliares. ­ Por fenómenos naturales tales como: temblores, inundaciones, incendios, descargas eléctricas, rayos etc. [. . . ] Å "PLAY PROGRAM" is displayed. Notes: ­ It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks. ­ If the total playing time is more than "99:59" then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 99 tracks, "FULL" is displayed. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. 7 Repeat play You can select and change the various play modes before or during playback. 1 Press REPEAT on the remote control repeatedly to select : "REPEAT TRACK" ­ to repeat playback of the current track. "REPEAT DISC" ­ to repeat playback of the current disc. "REPEAT PROGRAM" ­ to repeat playback of the programmed tracks. To resume normal playback, press REPEAT until "REPEAT OFF" is displayed. REP is shown, except for REPEAT OFF mode. Notes: ­ During programme play mode, it is not possible to repeat playback the current disc (Repeat Disc mode). ­ Pressing theÇSTOP button will cancel all repeat modes. 2 To review the programme G Stop playback and pressí or ë repeatedly. Notes: ­ GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively. ­ The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa. 3 Press PROGRAM again to store the radio station. PROG disappears. G Repeat steps 1­3 to store other radio stations. To exit manual preset mode G Press Ç on the system. Notes: ­ If you attempt to store more than 40 preset radio stations, "FULL" is displayed. ­ During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically. Tuning to preset radio stations G Once you've programmed the radio stations, press í or ë to select the desired preset number. The preset number, radio frequency, and waveband are displayed. For Recording, please refer to "Tape Operation/Recording". 19 English Manual Preset Programming Changing tuning grid (not available for Tape Operation/Recording English IMPORTANT!­ Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism. ­ C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system. [. . . ] This warranty extends only to defects in material or workmanship occurring under normal use of the product when operated in accordance with the instructions. 3. This warranty applies for original purchase only. It is not transferable if sold. or to find the location of your nearest recommended Authorised Service Centre outside the above cities please call our National Service telephone number: 1300-36-13-92 Please record the following information for your records and keep in a safe place. Model number:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]