User manual PHILIPS FW65C37

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] Notes: ­ Load the discs with the label side facing up. ­ To ensure good system performance, wait until the disc tray completely reads the disc(s) before proceeding. ­ For MP3 disc, the disc reading time may exceed 10 seconds due to the large number of songs compiled into one disc. 2 Selecting a desired track/passage To search for a particular passage during playback G Press and hold à or á and release it when the desired passage is located. During searching, the volume will be reduced. To select a desired track G Press í or ë repeatedly until the desired track is displayed. G If playback is stopped, press É to start Å playback. Playing discs To play all discs on the disc tray G Press É . Å All the available discs will play once, then stop. During playback, the selected disc tray, track number and elapsed playing time of the current track are displayed. For mixed mode discs, only one mode will be selected for playback depending on the recording format. To play the selected disc only G In CD mode, press DISC 1/2/3 (or CD DIRECT 1/2/3 on the remote control). The selected disc will play once, then stop. 17 English 2 CD/MP3-CD Operations English Selecting a desired Album/Title (MP3 disc only) To select a desired album G Press ALBUM -/+ (à or á) repeatedly. G To exit review mode, press Ç. Erasing the programme Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 99 tracks can be stored in the memory in any order. Load the desired discs on the disc tray (refer to "Loading discs"). G Press Ç once when playback is stopped or twice during playback. PROG disappears and "PROGRAM CLEARED" is displayed. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. For Recording, please refer to "Tape Operation/Recording". 18 1 2 3 Radio Reception English NEWS Tuning to radio stations 1 Press TUNER to select TUNER mode. A few seconds later, the current radio frequency will appear on the display. Press TUNER again to select the desired waveband : FM, MW or LW. Press and hold à or á until the frequency indication starts to change, then release. [. . . ] Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION "NO DISC" is displayed. Solution ­ Insert a disc. ­ Check if the disc is inserted upside down. [. . . ]