User manual PHILIPS FW750C

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] To load the third disc, press DISC CHANGE. The disc tray will rotate until the empty tray is ready for loading. 2 1 16 1 2 CD/MP3-CD Operations Press OPEN·CLOSE to close the disc tray. The selected disc tray, total number of tracks and the playing time will appear on the display. A lighted button indicates that a disc is loaded on the disc tray. For MP3 disc, the name of the first album and title will be scrolled through the display once and followed by "AXX TXXX". Notes: ­ Load the discs with the label side facing up. ­ To ensure good system performance, wait until the disc tray completely reads the disc(s) before proceeding. ­ For MP3 disc, the disc reading time may exceed 10 seconds due to the large number of songs compiled into one disc. Replacing discs during playback 1 2 Press DISC CHANGE. The disc tray will open without interrupting current playback. To change the inner disc, press DISC CHANGE again. "CHANGING DISC" is displayed and the disc will stop playing. To start programme play, pressÉÅ. 7 To resume normal playback, press MODE until "REPEAT OFF" is displayed. 2 Press MODE on the remote control to select: "SHUFFLE ON" ­ to random playback of the current disc. "SHUFFLE OFF" ­ to stop shuffle function and playback current disc. To resume normal playback, press Mode "SHUFFLE OFF" is displayed. REP or SHUF is shown, except SHUFFLE OFF mode. Note: ­ During program play mode or playing an MP3 CD, it is not possible to repeat playback of the current disc (Repeat Disc mode). Notes: ­ It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks. ­ If the total playing time is more than "99:59" then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "PROGRAM FULL" is displayed. ­ During programming, if no button is pressed within 25 seconds, the system will exit the programme mode automatically. To review the programme Stop playback and press TITLE -/+ ¡ / TM repeatedly. Erasing the programme Press STOP9 once when playback is stopped or twice during playback. PROG disappears and "PROGRAM CLEARED" is displayed. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order. 1 2 3 4 Load the desired discs on the disc tray (refer to "Loading discs"). [. . . ] Cleaning the disc lens After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. 28 Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. [. . . ]