User manual PHILIPS FW76/22B

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] 2 Press PROGRAM for more than one second. TM The PROG flag starts flashing and "AUTO" will be displayed. TM The system will search for every available station in the FM waveband first, then search the MW and LW bands respectively. TM All available stations will be stored automatically. The frequency and preset number will be displayed briefly. TM The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. TM The system will remain tuned to the last stored preset radio station. Manual programming 1 Press TUNER (BAND). 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press PROGRAM for less than one second. TM The next available preset number will be displayed for selection. To cancel NEWS function · Press NEWS again. TM The NEWS disappears and "NEWS OFF" will be displayed. English 16 Receiving RDS Radio Station Ç RDS (Radio Data System) is a broadcasting service that allows FM stations to send additional information along with the regular FM radio signal. This additional information can contain: · STATION NAME: The radio station name is displayed. · PROGRAM TYPE: The following program types exist and can be received by your tuner: News, Affairs, Info, Sport, Educate, Drama, Culture, Science, Varied, Pop M, Rock M, M. O. R. (middle of the road music), Light M, Classics, Other M, No type. · RADIO TEXT (RT): text messages appear in the display. When you have tuned to a RDS station, the RDS logo (Ç) and the radio station name will appear on the display: · The display normally shows the radio station name if available. Note: ­ When you press the RDS button and the display shows "NO RDS", it indicates that either the tuned station is not transmitting RDS signal or it is a non RDS station. RDS Clock Some RDS station may be transmitting a real clock time at an interval of every minute. Setting the time with RDS clock 1 Press CLOCK·TIMER. TM "--:--" or current time appears on the display. 2 Press CLOCK·TIMER once more to enter clock setting mode. TM "00:00" or current time starts flashing. [. . . ] · Tape dubbing is only possible in tape mode. Recording or playback cannot be made or there is a decrease in audio level. · Dirty tape heads, capstans or pressure rollers. TM See section on tape deck maintenance (page 23). [. . . ]