User manual PHILIPS FW880PP

[. . . ] FW880P-880W/22-Eng 6/15/00 4:06 PM Page 1 FW 880P Mini HiFi System with Dolby Pro Logic FW 880W 4:06 PM Page 2 FW880P-880W/22-Eng 6/15/00 FW880P FW880W English Français Español Deutsch Nederlands Italiano Svenska Dansk Suomi Português ÏÏËÓÈο 2 FW880P-880W/22-Eng 6/15/00 4:06 PM Page 3 INDEX Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] English 17 Reviewing the program Shuffle (only on remote control) Erasing the program (in the stop mode) · Press CLEAR on the system. TM "PROGRAM CLEARED" will be displayed. Playing the program 1 Press PLAY É to start program playback. TM "PLAY PROGRAM" appears on the display. TM The track number and elapsed playing time of the current track will appear on the display. · If you press REPEAT during program playback, the current track will be played repeatedly. TM The REPEAT and PROGRAM flags will be displayed. 2 Press STOP Ç to stop program playback. Note: ­ The program is also erased when the system is disconnected from the power supply. If the CD carousel is opened, the tracks belonging to the outer two trays will be erased and the display will show "CLEARED" . Repeat (only on remote control) It will play the current track repeatedly. TM "REPEAT TRACK" will be displayed. TM The REPEAT flag and the track selected appear on the display. · The track will be played repeatedly until you press STOP Ç. 2 Press REPEAT again to resume normal playback. TM The REPEAT flag disappears from the display. Note: ­ If you press any of the 3 CD DIRECT PLAY buttons, the system will play the selected disc or track and the stored program will be ignored temporarily. The program flag will also temporary disappear from the display and then reappear, when the playback for the selected disc ends. FW880P-880W/22-Eng 6/15/00 4:07 PM Page 18 TUNER DOLBY PRO LOGIC 20+ 18 17 16 15 14 13 CD TEXT 12 11 10 9 DBB TM The system will remain tuned to the last stored preset radio station. · Repeat the above procedure to store other preset stations for the other waveband. Remember to select the next available preset number before proceeding. If not, some of the preset radio stations may be erased. TUNING CLEAR SIDE A · B Tuning to radio stations 1 Press TUNER to select TUNER mode. A few seconds later, the current frequency or the radio station name if available will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press TUNING à or á for more than one second, then release. TM The display will show `SEARCH' until a station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. [. . . ] TM Press STANDBY-ON to switch the unit off; Remove the AC power plug from the wall outlet, then reconnect and switch on the system again. · Speakers are not connected or are connected wrongly. TM Check that the speakers are connected correctly. TM Make sure that the stripped speaker wire is clamped. Radio Reception Poor radio reception · The signal strength is too weak. [. . . ]