User manual PHILIPS FWB-C90

[. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. [. . . ] Å TM The selected track number and elapsed playing time appear on the display. selecting a desired track during playback · Press í or ë (or Digit 0-9 on the remote control) until the desired track appears on the display. TM The selected track number and elapsed playing time appear on the display. If you press í once it will skip to the beginning of the current track and play the track again. TM The total number of tracks programmed and total playing time appear on the display. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show "PROGRAM FULL". TM It will cancel any previously selected repeat mode. Repeat steps 3 to 5 to store other discs and tracks. Notes: ­ All the available discs will play once, then stop. ­ When the CD has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. ­ If the system is reading the disc, programming is not possible, "READING" will be displayed and followed by "DISC X" . "X" is the current read disc number. Repeat steps 3 ­ 5 to store other preset radio stations. 3 Press à or á for more than one second, then release. TM The display will show "SEARCH" until a radio station with sufficient signal strength is found. Repeat this procedure until the desired station is reached. To tune to a weak station, briefly press à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained. When a preset radio station is selected, the preset number appears next to the frequency on the display. ­ If you want to reserve a section of preset numbers, for example preset numbers 1 to 9, select preset 10 before starting automatic programming, only the preset numbers 10 to 40 will be programmed. TM The next available preset number will be displayed for selection. [. . . ] cleaning the Heads and the Tape Paths · To ensure good recording and playback quality, clean the heads, the capstan(s), and pressure roller(s) after every 50 hours of tape operation. Use a cotton swab slightly moistened with cleaning fluid or alcohol. You can also clean the heads by playing a cleaning tape once. demagnetizing the heads · Use a demagnetizing tape available at your dealer. [. . . ]