User manual PHILIPS FWC170

[. . . ] Mini Hi-Fi System FWC170 1 Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio FWC170 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] G If playback is stopped, pressÉ to start Å playback. Note: ­ In Shuffle mode, pressing í will cause the player to skip only to the beginning of the current track. To skip to the beginning of the current track during playback G Press í once. 1 Press SHUFFLE on the remote control. SHUF is shown and "SHUFFLE" is displayed. All the available discs or programmed tracks (if programme is active) will be played in random order. To resume normal playback, press SHUFFLE again. Notes: ­ During programme play or shuffling mode, it is not possible to repeat playback the current disc (Repeat Disc mode). ­ Pressing the OPEN / CLOSE button will cancel all repeat and shuffling modes. 2 CD Operation Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order. Erasing the programme G Press Ç once when playback is stopped or twice during playback. PROG disappears and "PROGRAM CLEARED" is displayed. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. 1 2 3 4 5 6 Load the desired discs on the disc tray (refer to "Loading discs"). Press í or ë repeatedly to select the desired track. Press PROGRAM to store the track. G Repeat steps 3­5 to store other discs and tracks. To end programming, press Ç once . PROG stays and the programme mode remains active. The total number of tracks programmed and the total playing time are displayed. To start programme play, pressÉ . Å "PLAY PROGRAM" is displayed. Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "FULL" is displayed. ­ During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically. To review the programme G Stop playback and press í or ë repeatedly. [. . . ] If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION "NO DISC" is displayed. Solution ­ Insert a disc. ­ Check if the disc is inserted upside down. ­ Wait until the moisture condensation at the lens has cleared. [. . . ]