User manual PHILIPS G290

[. . . ] 6 in1 PROFESSIONAL GROOMING KIT G290 Rechargeable Cordless 4203 000 54182 ENGLISH IMPORTANT SAFETY INSTRUCTIONS safety When using an electrical appliance, basic precautions should always be followed, including the following: Read all instructions before using this appliance. DANGER of electric shock: To reduce the risk 1. Do not reach for a Groomer that has fallen into water. Do not use while bathing or in a shower. Do not place or store Groomer where it can fall or be pulled into a tub or sink. [. . . ] 3 Detach the full width trimmer attachment by pushing the release button (fig. 4 Put the smaller neckline and sideburn trimmer attachment on the Groomer (fig. You will hear a click. Hold the Groomer upright when you use the smaller neckline and sideburn trimmer attachment (fig. Using Nose, Ear & Eyebrow Attachment 1 Be certain the Groomer is in the OFF position. 2 To attach or remove nose, ear, eyebrow attachment (or change attachments): Remove the AccuControl comb attachment Remove the full width trimmer attachment by Put the nose, ear, eyebrow attachment on the (fig. 9). pushing the release button (fig. 13). You will hear a click. Trimming Nose Hair Make sure nasal passages are clean. 1 Place nose, ear and eyebrow attachment on Groomer. 2 Switch the Groomer on and insert the tip of the attachment into one nostil (fig. CAUTION: Do Not insert the tip more than 3/16 in. /5mm into your nostril. 3 Slowly move the tip in and out while turning it around at the same time in order to remove unwanted hair. For best results, make sure the side of the tip is firm against skin. This will reduce the tickling effect that can occur during trimming of nose hair. Trimming Ear Hair Clean outer area of ear and ear canal. Make Nose, ear and eyebrow attachment should be sure it is free of wax. on the Groomer. 1 Switch the Groomer on and move the tip softly around the edge of ear to remove hairs extending beyond the outer ear (fig. 2 Carefully insert the tip into outer ear canal. CAUTION: Do not insert the tip further than 3/16 in. /5mm into the ear as this could cause damage to the eardrum (fig. Trimming Eyebrow Nose, ear and eyebrow attachment should be on Groomer. 1 Switch the Groomer on and use the tip to cut individual eyebrow hairs. The Groomer can be used for clipping single long hairs. 2 Put the Groomer at the root of the hair and move it along the edge of the eyebrow from the base of the nose towards the outer tip of the eyebrow in the direction of hair growth (fig. IMPORTANT: Do not use the Groomer to define or trim the entire eyebrow. Be careful not to get too close to your eyelashes and eyes! [. . . ] 2 Remove the old micro shaver cutter by pulling it from the appliance (fig. 3 Make sure that the spring within the driving unit does not get lost. 4 Insert the new micro shaver cutter carefully into the driving unit (fig. 5 When the micro shaver cutter is properly positioned, push it into its end position with your finger. [. . . ]