User manual PHILIPS G380

[. . . ] ALL IN 1 GROOMING SYSTEM G390, G380, G370 Rechargeable Cordless 4203 000 33381 ENGLISH IMPORTANT SAFETY INSTRUCTIONS safety When using an electrical appliance, basic precautions should always be followed, including the following: Read all instructions before using this appliance. DANGER of electric shock: To reduce the risk 1. Do not reach for a Groomer that has fallen into water. Do not use while bathing or in a shower. Do not place or store Groomer where it can fall or be pulled into a tub or sink. [. . . ] 2 Switch the Groomer on and insert the tip of the attachment into one nostril (fig. CAUTION: Do Not insert the tip more than 3/16 in. /5mm into your nostril. 3 Slowly move the tip in and out while turning it around at the same time in order to remove unwanted hair. For best results, make sure the side of the tip is firm against skin. This will reduce the tickling effect that can occur during trimming of nose hair. Trimming Ear Hair Clean outer area of ear and ear canal. Make Nose, ear and eyebrow attachment should be sure it is free of wax. on the Groomer. 1 Switch the Groomer on and move the tip softly around the edge of ear to remove hairs extending beyond the outer ear (fig. 2 Carefully insert the tip into outer ear canal. CAUTION: Do not insert the tip further than 3/16 in. /5mm into the ear as this could cause damage to the eardrum (fig. Trimming Eyebrow Nose, ear and eyebrow attachment should be on Groomer. 1 Switch the Groomer on and use the tip to cut individual eyebrow hairs. The Groomer can be used for clipping single long hairs. 2 Put the Groomer at the root of the hair and move it along the edge of the eyebrow from the base of the nose towards the outer tip of the eyebrow in the direction of hair growth (fig. IMPORTANT: Do not use the Groomer to define or trim the entire eyebrow. Be careful not to get too close to your eyelashes and eyes!Rinse attachment clean after each use. Shaving With Mini Shaver Attachment 1 Put the mini shaver attachment on the groomer (fig. 2 Use the narrow mini shaver to shave along contoured edges to remove any stubble while creating a smooth, welldefined beard line. Before using the mini shaver, always check it for wear and damage. If the mini shaver shows signs of wear or damage, do not use it as injury may occur. 8 Turn the Groomer off and remove the hair comb often to blow and/or shake out hair that has accumulated. REMEMBER:You must reset the hair length selector back to your desired setting every time you replace the hair clipping comb on the appliance. Contouring without the hair clipping comb attachment 1 Remove the hair comb by pressing and sliding the Hair Length Selector upwards (fig. [. . . ] 2 Allow the Groomer to run until the batteries are completely empty/depleted. 3 Insert a narrow, flat blade screwdriver in the groove next to the shaft at the top of the Groomer (fig. 4 Turn the screwdriver to separate the two housing halves. 5 Lift the battery out of the housing using the screwdriver (fig. [. . . ]