User manual PHILIPS GC1022/70

[. . . ] €¯2) 2 Fill the water tank to the MAX indication. €¯3) Do not pour vinegar or other descaling agents into the water tank. 3 Plug in the iron and set the temperature dial to MAX (Fig. 4 Unplug the iron when the temperature light goes out. [. . . ] Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €¯If you are unable to solve the problem with the information below, visit www. Solution Set an ironing temperature that is suitable for steam ironing. Temperature setting MAX 3 2 1 1 Steam setting ;, ;, ECO t t Steam boost Yes Yes No No No Spray Yes  Yes Yes No No You have put an additive in the water tank. The steam boost function does not work properly (water leaks out of the soleplate). You have used the steam boost function too often within a very short period. You have used the steam boost function at a too low temperature. Flakes and impurities come out of the soleplate during ironing. Water drips from the soleplate after the iron has cooled down or has been stored. Water leaks from the cap of the filling opening. When I push the steam control to the turbo steam position, the steam control jumps back. hard water forms flakes inside the soleplate. You have put the iron in horizontal position while there was still water in the water tank. You did not keep the steam control in the turbo steam position. Rinse the water tank and do not put any additive in the water tank. Wait a while before you use the steam boost function again. 2 Put the iron on its heel and plug it in. The temperature light goes on to indicate that the iron is heating up (Fig. [. . . ] Steam boost function -Press and release the steam boost button for a powerful boost of steam to remove stubborn creases (Fig. ECO steam setting -Select the ECO steam setting instead of the maximum steam setting ; to save energy, yet to achieve satisfactory ironing results. €¯10) Dry ironing -Set the steam control to t (dry ironing) to iron without steam. €¯2) Cleaning and maintenance Cleaning 1 Set the steam control to t (dry ironing), unplug the iron and let it cool down. [. . . ]