User manual PHILIPS GC2522

[. . . ] Shot of steam (specific types only) A powerful shot of steam helps to remove very stubborn creases. The shot-of-steam function only works at temperature settings between 2 and MAX. Vertical shot of steam (specific types only) You can also use the shot-of-steam function when you hold the iron in vertical position. This is useful for removing creases from hanging clothes, curtains etc. [. . . ] Automatic shut-off function (specific types only) The automatic shut-off function automatically switches off the iron if it has not been moved for a while. Note: If the temperature light does not go on after you move the iron, the soleplate still has the right temperature and the iron is ready for use. Double-Active Calc System (specific types only) The Double-Active Calc System consists of an Anti-Calc tablet inside the water tank combined with the CalcClean function. Calc-Clean function Use the Calc-Clean function once every two weeks. If the water in your area is very hard (i. Important Read this user manual carefully before you use the appliance and save it for future reference. danger Never immerse the iron in water. Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Do not use the appliance if the plug, the mains cord or the appliance itself shows visible damage, or if the appliance has been dropped or leaks. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. If you are unable to solve the problem with the information below, contact the Consumer Care Centre in your country. There is not enough water in the water tank. the steam control is set to position O. The soleplate is not hot enough and/or the drip-stop function has been activated (specific types only). the shot-ofsteam function does not work (specific types only). You have used the shot-of-steam function too often within a very short period. Put the iron on its heel and wait until the temperature light goes out before you start ironing. Continue ironing in horizontal position and wait a while before you use the shot-of-steam function again. Put the iron on its heel and wait until the temperature light goes out before you start ironing. Use the Calc-Clean function one or more times (see chapter `Cleaning and maintenance', section `Calc-Clean function'). [. . . ] Pick the iron up or move it slightly to deactivate the automatic shut-off function. Flakes and impurities come out of the soleplate during ironing. Water drips from the soleplate after the iron has cooled down or has been stored (specific types only). You have not closed the cap of the filling opening properly. [. . . ]