User manual PHILIPS GC 2965

[. . . ] Always place and use the iron on a stable, level and horizontal surface. Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the water tank. This appliance is intended for household use only. Instructions in this user manual, the appliance is safe to use based on scientific evidence available today. [. . . ] Features Spray function You can use the spray function at any temperature to moisten the article to be ironed. 1 Make sure that there is enough water in the water tank. Steam boost function A powerful boost of steam helps to remove very stubborn creases. The steam boost function only works at temperature settings between 3 and MAX. Vertical shot of steam You can also use the steam boost function when you hold the iron in vertical position. This is useful for removing creases from hanging clothes, curtains etc. Drip stop This iron is equipped with a drip-stop function: the iron automatically stops producing steam when the temperature is too low to prevent water from dripping out of the soleplate. When this happens you hear a click sound. Automatic shut-off function (specific types only) The automatic shut-off function automatically switches off the iron if it has not been moved for a while. To let the iron heat up again: 1 Pick up the iron or move it slightly. , Theautomaticshut-offlightstopsflashing. By doing this, you help to preserve the environment (Fig. If you need service or information or if you have a problem, please visit the Philips website at www. Com or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, contact the Consumer Care Centre in your country. There is not enough water in the water tank. The iron is not hot enough and/or the drip-stop function has been activated. set an ironing temperature that is suitable for steam ironing ( 2 to MAX). Put the iron on its heel and wait until the temperature light goes out before you start ironing. Cause You have used the steam boost function too often within a very short period. [. . . ] You have used the steam boost function at a setting below 3. You have used the steam boost function too often within a short period. Water drips from the soleplate after the iron has cooled down or has been stored. water spots appear on the garment during ironing. [. . . ]