User manual PHILIPS GC4596/40 STEAMGLIDEPLUS

[. . . ] 6) 8 ENGLISH Note: Make sure that the base sits on a stable and level surface. It is recommended to place the base on the soft part of the ironing board. 4 The light ring starts to flash blue light, indicating the iron is heating up. 7) 5 When the blue light turns steady, you can start ironing. [. . . ] Spray function -- Press the spray button to moisten the garment to be ironed. ENGLISH Steam boost function -- Press and release the steam boost trigger for a powerful boost of steam to remove stubborn creases (Fig. -- For optimal steam boost performance, it is recommended to press the steam boost trigger at a 5 seconds interval. Vertical steam -- You can use the steam boost function when you hold the iron in vertical position for removing creases from hanging clothes, curtains etc. €12) Ironing with extra steam -- For extra steam during ironing, press and hold the steam boost trigger. Eco steam setting / Dry ironing 9 -- In stead of Auto steam, you could choose ECO setting in the steam slider to save energy, yet to achieve satisfactory ironing results -- To iron without steam, select dry setting in the steam slider. Safety auto-off function -- The iron switches off automatically if the iron is not in use for 8 minutes. The light ring starts to slowly breath in blue to indicate the safety auto-off mode is activated. -- To let the iron heat up again, remove the iron (if the iron is on the base) and put it back to the base. €2) , unplug the base and let the iron cool 2 Pour any remaining water out of the water tank. 10 ENGLISH 3 Wipe flakes and any other deposits off the soleplate with a damp cloth and a non-abrasive (liquid) cleaning agent. 17) 5  et the iron cool down before you store it. L You can carry the iron and base by the iron handle. 18) Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Put the iron back to the base until the light ring turns steady blue light, indicating that the iron is ready for use again. 12 ENGLISH Possible cause Solution Problem The steam control is set to . Set the steam control to a steam setting (consult Table 1 in Chapter “using the appliance”). Consult Table 1 in Chapter “using the appliance” for temperature and steam setting. Put the iron back to its base to heat up and dry the soleplate. Put the iron back to its base to heat up and dry the soleplate. [. . . ] Make sure that the water filling door is closed properly. You are using a temperature of below 2 dots. You are using steam boost at a low temperature. You have used the steam boost function too often within a very short period. [. . . ]