User manual PHILIPS GC 4810

[. . . ] Register your product and get support at www. νικα 45 Español 58 Suomi 71 Français 84 Italiano 97 Nederlands 110 Norsk 123 Português 136 Svenska 149 Türkçe 162 GC4820, GC4810 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Carry case (GC4820 only) 2 Shot-of-steam button 9 3 Turbo steam button 0 4 Spray button T 5 Steam control -- 0 = no steam -- 1 = minimum steam -- 6 = maximum steam 6 Filling opening with cap 7 Spray nozzle 8 Temperature light 9 Calc-Clean button for cleaning/descaling 10 Temperature dial 11 Water level window 12 Soleplate 13 Stand 14 Filling cup 15 Stand clamp 16 Mode switch 17 Cordless ironing 18 Storage position 19 Corded ironing 20 Power unit 21 Mains cord with cord clip 22 Connection pins Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] Note:When you stop ironing for a while, always put the iron on the stand to let it reheat. Note:When you use the shot-of-steam or turbo-steam function, the iron may cool down rather quickly. We advise you to iron in corded mode when you use these functions. 12 English Ironing without steam 1 Set the steam control to position 0 (= no steam). 2 Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Selecting the temperature and steam setting’). Steam ironing 1 Make sure that there is water in the water tank. 2 Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Selecting the temperature and steam setting’). 4 Put the mains plug in the wall socket. As soon as the water in the water tank is hot enough for steam ironing, the temperature light goes out. 5 Set the appropriate steam setting (see chapter ‘Preparing for use’, section ‘Selecting the temperature and steam setting’). Note:The iron starts to produce steam as soon as it reaches the set temperature. Note: Steam ironing is only possible at higher ironing temperatures (temperature settings 2 to MAX). Features Spray function You can use the spray function to remove stubborn creases at any temperature. 1 Make sure that there is water in the water tank. English 2 Press the spray button several times to moisten the article to be ironed. 13 Shot of steam A powerful shot of steam helps remove stubborn creases. 1 Make sure that there is water in the water tank. 2 Press and hold the shot-of-steam button for a few seconds. Note:The shot-of-steam function can only be used at temperature settings between 3 and MAX. Vertical shot of steam -- You can also use the shot-of-steam function when you hold the iron in vertical position. This is useful for removing creases from hanging clothes, curtains etc. turbo steam The turbo-steam function helps remove difficult creases. [. . . ] Storage 1 Set the steam control to position 0, remove the plug from the wall socket and let the iron cool down. 16 English 4 Put the iron on the stand and set the mode switch to the storage position. -- The iron, the power unit and the stand are now locked together. 5 Wind the cord round the stand and fix the end of the cord with the cord clip. [. . . ]