User manual PHILIPS GC 4851

[. . . ] Register your product and get support at www. Com/welcome GC4800 series 1 English 6 Español 23 Italiano 42 Português 60 Türkçe 78 GC4800 series 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 2 3 4 5 6 Spray nozzle Filling opening Spray button Steam control Steam boost button Ionic DeepSteam button (GC4880, GC4875, GC4870 only) 7 Ionic DeepSteam light (GC4880, GC4875, GC4870 only) 8 Temperature dial 9 Amber temperature light (all types)/red autooff light GC4891/GC4890/GC4880/GC4875/ GC4870/GC4865/GC4860/GC4856/GC4855/ GC4852/GC4851/ GC4850 only). [. . . ] English 13 2 Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Selecting the temperature and steam setting’). 3 Set the appropriate steam setting (see chapter ‘Preparing for use’, section ‘Selecting the temperature and steam setting’). 4 Press the Ionic DeepSteam button once to switch on the Ionic DeepSteam function. , , The blue Ionic DeepSteam light goes on and you hear a humming sound. , , The iron now produces Ionic DeepSteam to help you remove even the toughest creases. 5 Press the Ionic DeepSteam button again to switch off the Ionic DeepSteam function. Note:The Ionic DeepSteam function is only effective when it is used in combination with a steam setting and a temperature setting between  2 and MAX. Note: Do not use the Ionic DeepSteam function when you iron without steam and/or at low temperature settings. However, ironing at low temperatures without steam with the Ionic DeepSteam function switched on will not damage the iron. 14 English Note:The Ionic DeepSteam output may vary from time to time, depending on the ironing temperature. Features Spray function You can use the spray function at any temperature to moisten the article to be ironed. 1 Make sure that there is water in the water tank. 2 Press the spray button several times to moisten the article to be ironed. steam boost function A steam boost from the special Steam Tip soleplate helps remove stubborn creases. The steam boost enhances the distribution of steam into every part of your garment. The steam boost function can only be used at temperature settings between 3 and MAX. 1 Press and release the steam boost button. Vertical steam boost 1 You can also use the steam boost function when you hold the iron in vertical position. This is useful for removing creases from hanging clothes, curtains etc. English 15 Drip stop This iron is equipped with a drip-stop function: the iron automatically stops producing steam when the temperature is too low, to prevent water from dripping out of the soleplate. When this happens, you may hear a sound. Automatic shut-off function (specific types only) The automatic shut-off function automatically switches off the iron if it has not been moved for a while. [. . . ] 3 Let the iron cool down in a safe place. 4 Wind the mains cord around the cord storage facility and fix it with the cord clip. 5 Store the iron on its heel in a dry and safe place. Heat-resistant protective cover (specific types only) You can store the iron on the heat-resistant protective cover immediately after ironing. [. . . ]