User manual PHILIPS GC6104

[. . . ] If steam continues to escape when the appliance is heating up, switch off the appliance and contact a service centre authorised by Philips. - Do not remove the steam tank cap from the steam tank when the steam tank is still under pressure. Do not use any other cap on the steam tank than the cap that has been supplied with the appliance, as the steam tank cap also functions as a safety valve. - Always place and use the iron and the steam tank on a stable, level and horizontal surface. [. . . ] Cold start: the soleplate takes approximately 2 minutes to heat up and the steam tank takes approximately 8 minutes to heat up. - Quick reheat: if you refill the steam tank during the ironing process, the water in the steam tank will take approximately 6 minutes to heat up. As soon as the water in the steam tank is hot enough for steam ironing, the steam tank power-on light goes out (GC6106, GC610, GC610, GC610 only). the steam-ready light goes on (GC6107 only). , During steam ironing the steam-ready light goes on from time to time. This indicates that the steam tank is being heated up to the right temperature. 5 Keep the steam activator pressed in while you are steam ironing. , If you want to use the steam function continuously, slide the steam activator lock to the locking position. If you have not used the steam function for some time, the steam that was still present in the supply hose will have condensed into water. When you start steam ironing again, this may cause some spluttering in the appliance and a few droplets of water may escape from the soleplate. Note:To prevent droplets from falling onto your garments, hold the iron over an old cloth and press the steam activator until the steam production has normalised before you start steam ironing again. ironing without steam 1 Select the recommended ironing temperature (see chapter `Preparing for use'). Do not press the steam activator while ironing. Some steam will escape if you press the steam activator by accident while you are ironing. To avoid this, you can simply set the steam tank switch to `off' to cut off the steam supply completely. If the steam tank is empty or has not heated up yet, you will hear a clicking sound inside the tank. This phenomenon is caused by the opening of the steam valve and is perfectly harmless. Features vertical steam ironing , Hanging curtains and clothes (jackets, suits, coats) can be steam ironed by holding the iron in vertical position. If you want to use the steam function continuously, use the steam activator lock. Variable steam (GC6107 and GC6104 only) The steam control is continuously adjustable and can be set to any position between MIN and MAX (see chapter `Preparing for use'). 'steam tank empty' light (GC6107 only) When the water in the steam tank runs out during use, the `steam tank empty' light goes on. 1 Refillthesteamtankwithwater(seechapter`Preparingforuse'). [. . . ] Elektromagnetiske felt (EmF) Dette Philips-apparatet overholder alle standarder som gjelder for elektromagnetiske felt (EMF). Supply hose Luz da temperatura Botão e indicador da temperatura Steam activator and lock D1- Bloqueio D2 - Activador Tampa do depósito do vapor Iron stand Steam tank Fio de alimentação Luz indicadora de vapor pronto (apenas GC6107) Steam tank switch with power-on light Controlo do vapor (apenas GC6107/GC6104) Iron switch with power-on light Luz indicadora de depósito do vapor vazio (apenas GC6107) Soleplate - If the mains cord or the supply hose is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Antes da primeira utilização 1 Remove any sticker or protective foil from the soleplate and clean the soleplate with a soft cloth. 1 Remove the mains plug from the wall socket. [. . . ]