User manual PHILIPS GC 6621

[. . . ] ENGLISH IMPORTANT - Cleaning and maintenance Smart Calc-Clean System Your appliance has been designed with a Smart Calc-Clean system to ensure that descaling and cleaning is done regularly. This helps to maintain a strong steam performance and avoids dirt and stains coming out of the soleplate over time. To ensure that the cleaning process is performed, the steam generator gives regular reminders. Besides that, a second defence step to protect the steam generator from scale is integrated: the steam function gets disabled if descaling is not done after 1 hour steam ironing once the reminder came up. [. . . ] 8 When the Calc-Clean process is completed, the iron stops beeping (Fig. 9 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 10 As the Smart Calc-Clean container becomes hot during the Calc-Clean process, wait approx. 11 Carry the Smart Calc-Clean container to the sink, empty it and store it for future use (Fig. 8 ENGLISH Safety auto-off mode (specific types only) -- To save energy, the steam generator switches off automatically when it has not been used for 10 minutes. The ‘iron ready’ light flashes. -- To reactivate the steam generator, set the on/off switch to ‘off ’ position and then to ‘on’ position. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. Problem The iron does not produce any steam. Possible cause There is not enough water in the water tank. Solution Fill the water tank beyond the MIN indication. Press and hold the steam trigger until steam comes out. It may take up to 30 seconds until steam comes out. Press and hold the steam trigger until steam comes out. turn the temperature dial to 2 or higher. Perform the Calc-Clean process within 1 hour after the Calc-Clean reminder is given. The Calc-Clean light flashes and the appliance beeps. The Calc-Clean light flashes and/or the appliance beeps. The Calc-Clean light flashes and the appliance beeps every time I press the steam trigger. You have not done or have Perform the Calc-Clean process to enable not completed the Calc-Clean the steam function again (see chapter process. [. . . ] Turn the temperature dial to the desired temperature setting instead of CÁLC CLEAN. Let the iron heat up until the ‘iron ready’ light lights up steadily. See chapter ‘IMPORTANT - Cleaning and You have not set the maintenance’. Temperature dial to CALC CLEAN or you have not waited for the iron to heat up. [. . . ]