User manual PHILIPS GC7610/20

[. . . ] English Caution: Do not use tap water, perfumed water, boiled water, water from a tumble dryer, rainwater, vinegar, mineral water, magnetically treated water (Aqua+), water from a drinking water filter, starch, descaling agents, ironing aids, salt or chemicals in the water tank. They are not suitable and may even cause damage to the appliance. If you use any of these types of water, your guarantee becomes invalid. 7 Using the appliance OptimalTemp technology Do not iron non-ironable fabrics. [. . . ] 1 Hold the iron in vertical position, press the steam trigger and touch the garment lightly with the soleplate. Never attempt to remove creases from a garment that someone is wearing. Do not apply steam near your or someone else’s hand. Putting down the iron during ironing -- During ironing, you can place the iron either on the iron platform or horizontally on the ironing board. Thanks to the OptimalTemp technology, the soleplate will not damage the ironing board cover. Energy saving ECO mode By using the ECO mode (reduced amount of steam), you can save energy without compromising on the ironing result. 1 To activate the ECO mode, press and hold the on/off button for 2 seconds. 2 To go back to the ‘OptimalTemp’ setting, switch the appliance off and on again. For the shortest ironing time, we advise you to use the ‘OptimalTemp’ setting. Safety auto-off (specific types only) The safety auto-off function automatically switches off the appliance if it has not been used for 5 minutes, to save energy. English Cleaning To properly maintain your appliance, clean it regularly. 1 Clean the appliance with a moist cloth. 2 To easily and effectively remove stains, let the soleplate heat up and move the iron over a moist cloth. 2 Pour the water out of the water tank into the sink. 5 Fold the mains cord and fasten it with the Velcro strip. 6 Specific types only:You can carry the appliance with one hand by the handle of the iron when the iron is locked on the iron platform. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €¯If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. 10 English Possible cause There is not enough water in the water tank. [. . . ] You can also add an extra layer of felt material under the ironing board cover to prevent condensation on the ironing board. Put an extra layer of felt material under the ironing board cover to prevent condensation on the ironing board. Activate the ECO mode to iron with a lower steam output. See section ‘Energy saving’ in this user manual. [. . . ]