User manual PHILIPS GC7635/30 PERFECTCARE PURE & GC7635/30,MV

[. . . ] This helps to maintain a strong steam performance and avoids dirt and stains coming out of the soleplate over time. To ensure that the cleaning process is performed, the steam generator gives regular reminders. Besides that, a second defence step to protect the steam generator from scale is integrated: the steam function gets disabled if descaling is not done after 1 hour steam ironing once the reminder came up. After descaling is done, the steam function will be restored. [. . . ] 2 To deactivate the TURBO mode, press and hold the on/off button for 2 seconds again until the light turns blue. Safety auto-off (specific types only) The safety auto-off function automatically switches off the appliance if it has not been used for 5 minutes, to save energy. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. € If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. Problem Possible cause Solution Fill the water tank beyond the MIN indication. Press and hold the steam trigger until steam comes out. It may take up to 30 seconds until steam comes out. Press and hold the steam trigger until steam comes out. Perform the calc-clean process to restore the steam function (see chapter ‘IMPORTANT - Cleaning and maintenance’). Perform the Calc-Clean process within 1 hour after the Calc-Clean reminder is given (see chapter ‘IMPORTANT - Cleaning and maintenance’). The iron does not There is not enough water in produce any steam. The steam function has been disabled until you have performed the Calc-Clean process. The light of the Calc-Clean button flashes and/or the appliance beeps. The light of the Calc-Clean button flashes and the appliance beeps every time I press the steam trigger. You have not done or have Perform the Calc-Clean process to enable not completed the Calc-Clean the steam function again process. This happens automatically when the steam generator has not been used for more than 5 minutes. Solution Set the on/off switch to ‘off ’ position and then to ‘on’ position. 9 The appliance produces a loud pumping sound. Water droplets come out of the soleplate. Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. Wipe the soleplate dry with a piece of cloth. [. . . ] There is a strong gush of steam when I release the steam trigger after placing the iron on the iron platform. Release the steam trigger 2 to 3 seconds before you place the iron back on the iron platform or ironing board. You do not press the steam trigger continuously. Keep the steam trigger pressed continuously when you move the iron over the fabric. [. . . ]