User manual PHILIPS PERFECTCARE COMPACT GC7833

[. . . ] ақша 125 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Read this user manual, the important information leaflet, and the quick start guide carefully before you use the appliance. 1) 1 2 3 4 5 6 7 8 9 10 11 12 13 Water supply hose Steam trigger/Steam boost 'Iron ready' light Soleplate Iron platform Carry lock release button Water tank filling door Water supply hose storage compartment Mains cord with plug CALC-CLEAN button with light On/off button with power-on light and auto-off light ECO button with light Smart Calc-Clean container Exclusive technology from Philips OptimalTemp technology The OptimalTemp technology enables you to iron all types of ironable fabrics, in any order, without adjusting the iron temperature and without sorting your garments. [. . . ] To ensure that the cleaning process is performed, the steam generator gives regular reminders. Sound and light Calc-Clean reminder After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. Besides that, a second defense step to protect the steam generator from scale is integrated: the steam function gets disabled if descaling is not done (Fig. After descaling is done, the steam function will be restored. This takes place regardless of the type of water used. Note: The Calc-Clean process can be performed at any time, even when the sound and light reminder is not activated yet. Performing the Calc-Clean process with the Calc-Clean container Warning: Do not leave the appliance unattended during the Calc-Clean process. Caution: Always perform the Calc-Clean process with the Calc-Clean container. Do not interrupt the process by lifting the iron up from the Calc-Clean container, as hot water and steam will come out of the soleplate. Note: Make sure that the appliance is plugged in and switched ON during the Calc-Clean process. 2 Place the Calc-Clean container on the ironing board or any other even, stable surface (Fig. 3 Place the iron stably on the Calc-Clean container (Fig. 4 Press and hold the CALC-CLEAN button for 2 seconds until you hear short beeps (Fig. It is perfectly safe to rest the iron on this container during the entire process. 5 During the Calc-Clean process, you hear short beeps and a pumping sound (Fig. 6 Wait approximately 2 minutes for the appliance to complete the process (Fig. When the CalcClean process is completed, the iron stops beeping and the CALC-CLEAN light stops flashing. 7 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 8 As the Calc-Clean container becomes hot during the Calc-Clean process, wait approx. Then carry the Calc-Clean container to the sink, empty it and store it for future use (Fig. 9 If necessary, you can repeat steps 1 to 8. Make sure that you empty the Calc-Clean container before you start the Calc-Clean process. [. . . ] The appliance then starts to when the appliance has not heat up again. Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. Wipe the soleplate dry with a piece of cloth. If the Calc-Clean light still flashes and the appliance still beeps, perform the Calc-Clean process (see chapter 'Cleaning and maintenance'). [. . . ]