User manual PHILIPS GC 8410

[. . . ] аҚша 55 Lietuviškai 64 Latviešu 72 PoLski 80 roMână 89 русский 97 sLovensky 106 sLovenšČina 115 srPski 123 українська 131 GC8400 SERIES 6 EnGlISh Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Two steps for ergonomic ironing 1 Ergonomic iron design The upward-sloping handle ensures a comfortable position of the wrist. 2 Ergonomic iron resting mat To reduce the strain on your wrist, the iron resting mat allows you to place the iron horizontally on the ironing board. [. . . ] Do not place the mat with hot iron on a surface that can be scorched by heat. Note: Do not touch the iron resting mat for some time after you have removed the hot iron from it, as the mat is hot. Steam boost function (gC8461/gC8460 only) During steam ironing, you can use the steam boost function to remove stubborn creases. 1 Set the temperature dial to a setting between 3 and MAX. Note: Some water droplets may appear when you use the steam boost function for the first time. The water droplets disappear after you have used the steam boost function for some time. Cleaning and maintenance Calc-Clean function 1 Never remove the Calc-Clean rinsing cap when the steam generator is hot. Note: Rinse the steam generator once a month or after every 10 times of use to prevent damage to the appliance and for optimal steaming performance. 1 Unplug the appliance and let it cool down for 2 hours. Hold the steam generator with both hands and shake well. 4 Empty the steam generator into the sink. 5 Fill the steam generator with fresh water, shake well and empty it into the sink again. 6 Repeat step 5 a few times to obtain the best result. 7 Screw the Calc-Clean rinsing cap tightly back onto the steam generator and put back the Calc-Clean rinsing flap. 8 Put the water tank back into the steam generator. storage 1 Switch off the appliance and unplug it. 1 2 Be careful with the iron resting mat, it may be hot after use. 3 Insert the tip of the iron into the carry lock (1) and then put down the heel of the iron (2). 4 Slide the carry lock slide to the right to lock the iron onto the steam generator. 5 GC8461/GC8460: Press the cord rewind button to rewind the mains cord. 6 GC8420/GC8410: Insert the cord neatly into the cord storage compartment. EnGlISh 7 Wind the supply hose around the base and secure it inside the storage hooks. [. . . ] Wet spots appear on the garment during ironing. The wet spots that appear on your garment after you have steam ironed for some time may be caused by steam that has condensed onto the ironing board. Press the steam trigger and keep it pressed while you steam iron. Slide the water tank firmly back into the steam generator (‘click’). [. . . ]