User manual PHILIPS GC9920

[. . . ] 2 minutes the iron is ready for use. 8 You can store the hot iron in the heat-resistant storage compartment immediately after you have switched the iron off. 2 Steaming A Hanger hook D Air vent slide USteamer power-on button with light VBlowing/suction button T Steam activator H Board tilting button I Height adjustment lever J Locking strap M Mains plug E Steaming tips and tricks · The steamer is perfect for all delicate fabrics, such as silk, wool and cashmere. · To steam a jacket, put it directly on the board. To steam a blouse or a dress, use the hanger hook A. 1 Put the mains plug M in an earthed wall socket. [. . . ] Wait until the light on the iron/steamer stops blinking and starts burning continuously. The refreshing mode runs for 10 minutes and then switches off automatically. You can switch the refreshing mode back on by pressing the refreshing button. There may not be enough water in the water tank or the water tank is not properly placed in the water tank compartment. Fill the water tank and put it back into the water tank compartment properly. The appliance may not be hot enough for steaming. Wait until the light on the iron/steamer stops blinking and starts burning continuously. Then press the steam activator to start steaming. You may not have pressed the steam activator. Press the steam activator on the handle of the iron/steamer to start steaming. Why does the refreshing mode switch off?Why doesn't the iron/steamer produce any steam? Why does the appliance produce noise? When you hear an intermittent noise, water is intermittently pumped from the water tank into the boiler. If the noise continues for a long time or if it becomes very loud, first check whether the water tank is properly inserted into the appliance. If this is the case but the noise still persists, switch off the appliance and contact the Philips Customer Care Centre or your Philips dealer. The appliance is equipped with an illuminiated fan that runs continuously during use. This fan optimises the performance of the appliance and cannot be switched off. Why is the airflow insufficient? The air vent slides are probably in the wrong position. In ironing and steaming mode, the air vents must be closed by setting both air vent slides to the ironing position. It is normal for some air to come out of the vents after they have been closed; this does not affect the performance of the appliance. In refreshing mode, the air vents must be opened by setting both air vent slides to the refreshing position. If the ironing board is used for a prolonged period, too much steam condenses inside the ironing board, causing wet spots on the cover. After use, leave the ironing board folded out for some time to let it dry. Alternatively, press the refreshing button and let the fan operate until the appliance switches off automatically after 10 minutes. Water collects inside the hose of the iron/steamer. [. . . ] - Children should be supervised to ensure that they do not play with the appliance. - Never remove the ironing board cover while ironing or immediately after use. Always let the appliance cool down sufficiently before you remove the cover. - The soleplate of the iron can become extremely hot and may cause burns if touched. [. . . ]