User manual PHILIPS HB567

[. . . ] Just as with natural sunlight, overexposure must be avoided (see chapter 'Tanning and your health'). 1) A B C D Tube lamps and starters of the couch Tube lamps and starters of the canopy Facial tanner - HB567 only Switches for facial tanner - HB567 only - O = facial tanner off - I = facial tanner on - I and , = facial tanner on at 75% of its full intensity - I and m = facial tanner on at full intensity Fan for body cooling Switches for fan - O = fan off - I = fan on - I and n = one fan on - I and b = both fans on End cover Mains cord Legs of the frame and side panel Connecting cable between couch and canopy Fan to cool the facial tanner (HB567 only) Vents and fans to cool the tube lamps Acrylic sheets Protective foils Protective goggles (2 pairs) - (type no. 4822 690 80147) Screws and bolts Spanner and screwdriver Timer Important Check if the voltage indicated on the canopy corresponds to the mains voltage in your home before you connect the appliance. Water and electricity are a dangerous combination! [. . . ] Take one tanning session a day for five to ten days. Wait at least 48 hours after the first session before taking the second session. After this 5 to 10-day course, we advise you to give your skin a rest for a while. Approximately one month after a course, your skin will have lost much of its tan. If you want to keep your tan, do not stop tanning after the course, but continue taking one or two tanning sessions a week. Whether you choose to stop tanning for a while or whether you continue tanning on a lower frequency, always keep in mind that you must not exceed the maximum number of tanning hours. For this appliance the maximum is 20 hours (= 1200 minutes) a year. Example Suppose you are taking a 10-day course, consisting of a 8-minute tanning session on the first day and a 25-minute tanning session on the following nine days. The entire course will then last (1 x 8 minutes) + (9 x 25 minutes) = 233 minutes. This means you can take 5 of these courses a year, as 5 x 233 minutes = 1165 minutes. Table As is shown in the table, the first session of a tanning course should always last 8 minutes, irrespective of the sensitivity of the skin. 8 Insert the mains plug into the wall socket. For the correct tanning times, see 'Tanning sessions: how often and how long?2 Push the canopy backwards so that you can lie down on the couch. When you are lying on the couch, pull the canopy back into horizontal position (fig. NB: when the appliance has not been used for some time, the hinges of the canopy may squeak when you open or close the canopy for the first time. 3 Switch the body cooler on by means of the switch (fig. 4 HB567 only: if you like, you can also switch on the facial tanner (fig. 5 Don't forget to put on the protective goggles provided. 6 During the last minute of the session you will hear a beeping sound. Cleaning Always unplug the appliance and let it cool down before you start cleaning it. Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the acrylic sheet as this may cause irreparable damage. [. . . ] 8 The starters can be removed by turning them to the left. 9 Insert new lamps and/or starters and follow the instructions above in reverse direction and order to reassemble the appliance. 10 Do not forget to fasten the end cover with the screws again. HB567 only The HPA lamp of the facial tanner may only be replaced by a service centre authorised by Philips. [. . . ]