User manual PHILIPS HB568

[. . . ] - If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. - If the wall socket used to power the appliance has poor connections, the plug of the appliance becomes hot. Make sure you plug the appliance into a properly connected wall socket. - The appliance must be connected to a circuit that is protected with a 16A standard fuse (in the UK 13 A fuse) or a slow-blow automatic fuse. [. . . ] some medications and cosmetics increase the sensitivity of the skin. It is therefore highly important: - that you follow the instructions in chapter `Important' and section `Tanning sessions: how often and how long?'; - that you do not exceed the maximum number of tanning hours per year (see section `Tanning sessions: how often and how long?' for your type of appliance); - that you always wear the goggles provided while tanning; - that the tanning distance (distance between the canopy and your body) is at least 20cm. HB568:tanning sessions: how often and how long?Do not take more than one tanning session a day, over a period of 5 to 10 days. Take a break of at least 48 hours between the first and the second session. After this 5 to 10-day course, we advise you to stop tanning for a while. Approximately one month after a course, your skin will have lost much of its tan. If you want to keep your tan, do not stop tanning after the course, but continue with one or two tanning sessions a week. Whether you choose to stop tanning for a while or whether you continue tanning on a lower frequency, always keep in mind that you must not exceed the maximum number of tanning hours. Because your skin feels taut and tender after the session), we advise you to reduce the length of the sessions by e. For a beautiful all-over tan, turn your body slightly during the session so that the sides of your body are better exposed to the tanning light. If your skin feels slightly taut after tanning, you can apply a moisturising cream. Preparing for use Fixing the stand Always assemble and move the canopy together with another person. 4 Fasten the rod to the base by tightening the socket-head screws with the hexagon key (Fig. With this appliance, you can tan either lying, (Fig. If you intend to tan lying, the distance between the acrylic sheet and the surface you lie on (bed, couch or settee) must be at least 40cm (Fig. Height adjustment 1 Give the height adjustment knob two or three turns anticlockwise to release the rod (Fig. 3 To lock the rod in position, turn the height adjustment knob clockwise until tight (Fig. Check if the distance between your body and the canopy is at least 0cm. Only use these protective goggles when you tan with a Philips tanning appliance. [. . . ] Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the acrylic sheet as this may cause irreparable damage. 1 Clean the outside of the appliance with a damp cloth. Do not let water run into the appliance. [. . . ]