User manual PHILIPS HB590

[. . . ] Introduction Full-body tanner with integrated facial tanning unit With this tanning appliance you can suntan comfortably at home. The tanning lamps emit visible light, heat and ultraviolet light, giving you the impression you are sunbathing in real sunlight. This appliance tans your whole body, including the sides, evenly from head to toe. A timer ensures that each tanning session does not last longer than 30 minutes. [. . . ] Approximately one month after a course, your skin will have lost much of its tan. If you want to keep your tan, do not stop tanning after the course, but continue taking one or two tanning sessions a week. Whether you choose to stop tanning for a while or whether you continue tanning on a lower frequency, always keep in mind that you must not exceed the maximum number of tanning hours. For this appliance the maximum is 17 hours (= 1020 minutes) a year. Example Suppose you are taking a 10-day course, consisting of a 6-minute tanning session on the first day and a 20-minute tanning session on the following nine days. The entire course will then last (1 x 6 minutes) + (9 x 20 minutes) = 186 minutes. This means you can take 5 of these courses a year, as 5 x 186 minutes = 930 minutes. Table As is shown in the table, the first session of a tanning course should always last 6 minutes, irrespective of the sensitivity of the skin. If you think that the sessions are too long for you (e. If the skin gets taut and tender after the session), we advise you to reduce the sessions by e. Duration of the tanning session in minutes 1st session rest of at least 48 hours 2nd session 3rd session 4th session 5th session 6th session 7th session 8th session 9th session 10th session 10 10 10 10 10 10 10 10 10 15-20 15-20 15-20 15-20 15-20 15-20 15-20 15-20 15-20 25 25 25 25 25 25 25 25 25 for persons with very sensitive skin 6 for persons with normal sensitive skin 6 for persons with less sensitive skin 6 Preparing for use It requires two people to assemble and move the tanning appliance. During assembly the appliance becomes heavier and more difficult to move. We therefore advise you to assemble the appliance at the place where it will be used. Make sure there is enough free space beside (at least 50 cm) and behind (at least 30 cm) the appliance. If the couch and/or canopy have to be placed on the floor, put them on the floor with the tube lamps facing downwards to avoid internal damage. Make sure you place them on a soft surface (e. NB: the holes in the side panels must be on the front side. 1 First assemble the legs of the frame by fastening the angle sections with the bolts and then fit the side panels, if applicable (fig. Make sure the legs slide steadily into the appropriate openings in the couch (fig. NB: the openings for assembling the canopy must be located at the back of the couch. 3 If necessary, you can move the couch slightly by sliding its legs across the floor or by carefully lifting it slightly off the floor together with another person. Make sure there is enough free space beside (at least 50 cm) and behind (at least 30 cm) the appliance. [. . . ] Do not let any water run into the appliance. The light emitted by the tanning lamps will become less bright in time (i. After a few years in case of normal use). When this happens, you will notice a decrease in the tanning capacity of the appliance. [. . . ]