User manual PHILIPS HD3271

[. . . ] ⷠOnly touch the heater with dry hands. Do not use the heater in rooms with explosive gas (e. A safe area to be left free is 50 cm / 20" at the top and at the sides, and 120 cm / 47" at the front. ⷠPrevent overheating of the appliance by keeping the air inlet and outlet grilles free: do not hang anything in front of it or above it otherwise there is a risk of fire. [. . . ] If overheating should occur, the built-in overheating safety device will switch off the appliance. ⷠKeep the mains cord at a safe distance from the air inlet and outlet grilles. ⷠDo not allow aerosols, inflammable substances or materials sensitive to heat to be in the flow of hot air. Air inlet grille Air outlet grille Selector switch Thermostat knob Pilot light Mains cord storage Stand / wall bracket (only type HD 3275) The heater must not be located immediately below a socket outlet. ⷠOnly use the fan heater when it is standing (fig. For your own safety and that of others: water and electricity are a dangerous combination!When using the heater in the free standing mode do not place it in the immediate surroundings of a bath, a shower or a swimming pool. Ensure that the appliance cannot fall into water (bath, wash basin, shower cubicle, etc. Wall-mounting (only for type HD 3275) This model can be used as a free-standing unit, but it can also be mounted to a wall using the stand / wall bracket (G). This wall should be solid, flat and fireproof. - Using a small screwdriver push the small lip downwards (fig. You may adjust the thermostat during use. ) - As soon as the temperature is comfortable, turn the knob clockwise slowly until the heater goes off. This position corresponds with the minimum thermostat setting (i. +5 °C / +41 °F) and can be used to keep the immediate vicinity of the heater free from frost. To prevent pipes from freezing, position the heater close to the pipe and select this position. Please note: When using the cool air setting >, the thermostat knob should be in its highest position. Pilot light - When the appliance is connected to the mains and switched on by selecting >, 1 or 2 the pilot light (E) will come on. - The light will stay on until the appliance is switched off by setting the selector switch (C) to position O or by disconnecting from the mains. - To indicate that the heater is still connected and in "switched-on" position (>, 1 or 2), the pilot light will remain on when the set temperature is reached and the thermostat switches the appliance off. For the same reason the pilot light will remain on when the overheating safety device switches the appliance off. Overheating safety device To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power as soon as the heating elements become too hot. [. . . ] Overheating safety device To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power as soon as the heating elements become too hot. If this should happen: - First ensure that it was not the thermostat which has switched off the heater. set the thermostat to maximum position. If the heater does not switch on, the safety device has been activated. [. . . ]