User manual PHILIPS HD3455

[. . . ] ⷠThe appliance shall not be located below a socket outlet. It may happen, especially if the heater operates on position · ⷠAnd another electrical device is switched on as well, that a fuse or circuit breaker cuts off the mains power. In such a case, the fuse or circuit breaker may not allow this high electrical power. You may connect one of the involved appliances to another circuit (employing another fuse or circuit breaker) or have the electrical installation revised by an authorized electrician. [. . . ] ⷠSelect a safe spot to avoid electrical shock and the risk of fire. ⷠThis appliance can be used as a free-standing unit by means of the stands (G). However, it can also be mounted to a (fireproof!This wall should be solid, flat and fireproof. 2a) Mount the two stands (G) before using the heater standing upright for the first time. (Do not mount the stands if you wish to use the heater hanging on the wall. ) - Slide the two stands into the special holders in the direction of the arrows until "Click" is heard. 2b) - Pull the lip a little upwards using a pair of pliers while sliding the stand out of the holder. Wall-mounting - Drill the holes and fix the brackets to the wall using screws and rawlplugs (fig. ) Subsequently, the heater will keep keep the surrounding air at the set temperature by switching on and off at intervals. You may adjust the thermostat during use. - As soon as the temperature is comfortable, turn down the thermostat knob slowly until the heater goes off. - The light will stay on until the appliance is 8 switched off by setting switch (C) or (D) back into the original position (fig. ), the pilot light will remain alight when the set temperature is reached and the thermostat switches the appliance off. type HD 3455: "Turbo" position (fig. 9) To make the temperature rise more rapidly, you may switch on the fan at the extra air outlet opening (B2). - Secure with the two screws on the sides of the brackets (fig. Please note: do not lead the mains cord upward at the back side of the wallmounted heater. The fan will accelerate the flow of heated air, especially if heat setting · A water pipe must be prevented from freezing: - Position the heater 10 (standing upright!(depending on the size of the room, possible draught and the expected minimum temperature); - Set the thermostat dial to position y (i. [. . . ] Wait for the heater to cool down sufficiently. - You may clean the outside of the heater with a damp cloth. Make sure that no water runs into the appliance. - The air inlet opening (A) and if necessary also the air outlet opening(s) (B1, B2) may be cleaned using the vacuum cleaner with small long-haired nozzle. [. . . ]