User manual PHILIPS HD3522

[. . . ] The heater is not designed for use as the main source of heating. Use the appliance only for its intended purpose, i. For your own safety and that of others, be aware that water and electricity are a dangerous combination!When you use the heater standing on the floor, do not place it in the immediate surroundings of a bath, shower or swimming pool. [. . . ] Position the appliance in such a way that the airflow into and out of the appliance is not obstructed. Put the appliance in a safe place to avoid electrical shock and the risk of fire. - This appliance can be used standing on the floor or it can be mounted to a (fireproof!) wall by means of the bracket (H) (type HD 3522 only). The wall to which it is mounted must be solid, even and fireproof. Mounting the appliance to the wall (type HD 3522 only) - Push the small lug on the bracket (H) downwards with a small screwdriver (fig. 4) and pull the bracket off the appliance (fig. - Push the small lug on the bracket downwards by means of a screwdriver and simultaneously pull the appliance off the bracket. For your safety, the bracket has been designed in such a way that it is not possible to remove the heater from the bracket without using a tool. How to use the appliance The selector switch (C) and the thermostat control (D) enable you to select the following functions: Selector switch (C) O = Off. Both the fan and the two heating elements are switched off. Half power: the fan and one of the two heating elements are switched on. 2 = High position for quick heating-up. Full power: the fan and the two heating elements are switched on. Thermostat control (D) With the thermostat knob you can set a constant room temperature. When the selector switch is set to position 1 or position 2, the heater will automatically switch on (at half power or full power respectively) as soon as the room temperature falls below the set temperature. Turn the control clockwise to select a higher temperature setting or anti-clockwise for a lower temperature setting. You can adjust the thermostat during use. To find the ideal thermostat setting: - First set the thermostat control to maximum position by turning it clockwise until it will not go any further. - As soon as you find the temperature in the room agreeable, slowly turn the thermostat control anticlockwise to the point where the heater switches off. Please note that when you use the cool air setting >, the thermostat control must be set to maximum position. This position corresponds with the minimum thermostat setting (i. [. . . ] If necessary, clean the grilles with a vacuum cleaner. - Put the plug back into the wall socket and switch the heater on again. If the safety cut-out switches the heater off again: - Remove the mains plug from the wall socket. - Remove the mains plug from the wall socket. [. . . ]