User manual PHILIPS HD3802

[. . . ] If you have not used the water purifier for more than two weeks, let the water run at the filtered setting for 2-3 minutes before use. If the filter cartridge emits an unpleasant smell, replace it with a new one. During use Only use the water purifier to filter water that meets drinking water standards. Do not block the filtered water outlet or connect other devices to it. [. . . ] Screw the D-type adapter about halfway onto the water selection unit. Make sure to leave enough room in order to tighten the fitting at a later step. 16) Push the water selection unit firmly onto the tap from below and tighten the screws evenly. Make sure that you keep the tap in the center of the screw fastener. At the same time maintain pressure on the water purifier housing from below. Tighten the attachment nut firmly onto the water selection unit (Fig. Make sure the rubber washer is firmly pushed against the tap to prevent water leakage. Connecting the hose to the water selection unit 1 Make sure the tap is closed. Remove the hose joint from the water selection unit (Fig. Push the hose onto the connection point until it does not go any further () (Fig. Use the nylon fasteners to fasten the hose along the tap (Fig. Using the water purifier The water selection unit has 4 settings: filtered spray, filtered stream, unfiltered spray and unfiltered stream. Do not let water hotter than 50°C run through the water purifier, as this may damage the water purifier. Filtered water (spray or stream) Select this setting for drinking, washing vegetables or fruits and for cooking. 1 Turn the swivel arm to the desired position. Turn the water selection lever on the water selection unit until the filtered water symbol is aligned with the indicator (Fig. Move the swivel nozzle until it is in the desired position If you filter water between 35°C and 50°C, the water may have an unpleasant smell. The filter cartridge has absorbed this smell during filtering, but releases it again if you filter water hotter than 35°C. Unfiltered water (spray or stream) spray Select this setting for washing dishes and other jobs that require a gentle water flow. 1 Turn the water selection lever on the water selection unit until the unfiltered spray symbol is aligned with the indicator (Fig. Unfiltered stream Select this setting for a strong water flow. 1 Turn the water selection lever on the water selection unit until the unfiltered stream symbol is aligned with the indicator (Fig. [. . . ] You may need to wind some Teflon tape around the thread of the tap adapter. Water leaks from the bottom of the filter housing unit. Perhaps the filter cartridge is not properly installed. Perhaps the stainless steel screen under the The water flow is weak at the unfiltered rubber washer inside the water selection unit is setting. [. . . ]