User manual PHILIPS HD4686

[. . . ] Excess cord can be stored in or around the base of the appliance. Keep the cord, the base and the kettle away from hot surfaces. Do not use the appliance if the mains cord, the plug, the base or the appliance itself is damaged. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. [. . . ] You can adjust the set temperature while the kettle is operating. This is only possible if the temperature of the water is still below the newly set temperature. Note: If you remove the kettle from the base, the set temperature is lost. Keeping water warm You can use the keep-warm function to keep water warm at a temperature of 100°, 80°, 60°C or 40°C. There are two ways to keep water warm: at the current temperature, or at a temperature higher than the current temperature. If there is too little water in the kettle, the kettle may switch offwithin30minutestoprotecttheheatingelement. Note: If the current temperature is lower than 60°C, you first have to set the temperature (see point B below). B keeping water warm at a higher temperature than the current temperature 1 Press the SET TEMP button one or more times to set the desired temperature (see section `Setting the temperature'). When the kettle heats up the water to keep it at the selected temperature, the light of the desired temperature flashes. When the water has reached the selected temperature, the light of the desired temperature lights up continuously. , After30minutes , youhearanaudiblesignalandthekettleswitches offautomatically. Note:You can always stop the keep-warm process at any time. Note: If you remove the kettle from the base, the set keep-warm temperature is lost. Note: If the selected keep-warm temperature is 100°C, the kettle keeps the water at a temperature between 90°C and 100°C to avoid excessive steam development. If the selected keep-warm temperature is 80°, 60° or 40°C, the kettle keeps the water at a temperature between 5°C below and 5°C above the selected temperature. Never immerse the kettle or its base in water. Do not let the moist cloth come into contact with the cord, the plug and the connector of the base. Cleaning the filter Scale is not harmful to your health but it may give your drink a powdery taste. The anti-scale filter prevents scale particles from ending up in your drink. Clean the Triple action anti-scale filter regularly in the following way: 1 Taketheentirefilteroutofthekettle(Fig. Note:You can also clean the filter in two other ways. Leave the filter in the kettle when you descale the kettle (see section `Descaling the kettle') or remove it from the kettle and clean it in the dishwasher. [. . . ] The kettle keeps the water warm for 30 minutes and then switches off automatically. To keep the water hot longer, press the keep-warm button again. Solution You may not have pressed the on/off button within 10 seconds after setting the temperature. In this case, the set temperature is lost and you have to set the temperature again. [. . . ]