User manual PHILIPS HD7110

[. . . ] â· Use the appliance out of children's reach. Never use the appliance if the mains plug, the mains cord or the appliance itself is damaged. 1) You can keep excess mains cord rolled up around the back plate. [. . . ] - Fill the filter evenly with the required quantity of ground coffee (fig. When you use large cups, it is advisable to take one full (heaped) measuring spoonful of ground coffee for each cup. â· When you use smaller cups, it is advisable to take one level (flat) measuring spoonful of ground coffee for each cup. use "Fast Filter" type coffee. If you grind the coffee yourself, do not grind it to a fine powder. You can adapt the quantity of coffee to your personal taste. The pilot light of the on/off switch will now come on. â· The automatic "drip-stop" (stop-valve) ensures that no coffee will drip on the hotplate if you - remove the jug from the appliance for a moment during the brewing process; - remove the jug after making coffee. please note: the "drip-stop" will only function properly if the jug lid has been placed. After making coffee - When the last coffee has dripped out of the filter, you can take the jug (with the lid) out of the appliance (fig. - Put the jug back on the hotplate to keep the coffee warm. Coffee taste and temperature are then maintained (fig. However, coffee is at its best directly after it has been made!When you decide to stop keeping coffee hot, switch the appliance off (fig. After drinking coffee swing the filter holder out of the appliance (fig. Throw away the paper filter with contents (fig. If using a permanent filter: lift the permanent filter out of the filter holder and throw away the contents (fig. If you have your coffee ready and wish to make some more right away, please switch the appliance off and allow about four minutes for it to cool down. [. . . ] Only WARNING THIS APPLIANCE MUST BE EARTHED The wires in this mains lead are coloured in accordance with the following code: GREEN AND YELLOW - EARTH BLUE - NEUTRAL BROWN - LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter "E" or by the earth symbol E or coloured GREEN or GREEN AND YELLOW. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter "L" or coloured RED. The wire which is coloured BLUE must be connected to the terminal which is marked with a letter "N" or coloured BLACK. [. . . ]