User manual PHILIPS HD7830

[. . . ] HD7830 Coffee Machine 1 h 2 3 4 5 A i 6 J B F g K 7 8 9 10 11 12 13 C l M 14 D 15 16 17 n E 18 19 20 21 22 23 24 25 O P Q R 26 27 28 29 30 31 32 33 34 35 English introduction With Douwe Egberts SENSEO\ coffee pods, you can enjoy a perfect cup of coffee at any time of the day. Every cup is freshly brewed to give you that smooth and full taste. Using more than 250 years of coffee expertise, Douwe Egberts has roasted and ground specially selected coffee beans that, when prepared using a special brewing method co-developed with Philips, ensure a full, smooth taste and delicious foam layer. This joint creation, known as the SENSEO\ coffee pod system, consists of the Philips SENSEO\ coffee machine and specially developed Douwe Egberts SENSEO\ coffee pods. [. . . ] - The machine automatically supplies the selected amount of water. - You can interrupt the brewing process at any time by pressing the on/off button 3. If you switch the machine back on after having interrupted the brewing process, the machine will not complete the interrupted brewing cycle. Do not remove the water reservoir during a brewing cycle, as this will cause the machine to draw in air. When this happens, the next cup will only be partly filled. Note: If you only get a small quantity of coffee or no coffee at all out of the machine, you have not flushed the machine properly before first use. As a result, the boiler is not or not completely filled. Flush the machine properly (see chapter `Preparing the machine for use') before you brew another cup of coffee. 11 Remove the coffee pod(s) after use by lifting the pod holder out of the machine and emptying it. Be careful when doing this, for there may still be some water/coffee on the coffee pod(s). , , , Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. If it does, the coffee machine will start leaking!Flushing If you have not used the coffee machine for three days, you have to flush it with fresh water before you use it again. Flush the machine in the following way: 1 Fill the water reservoir with cold water up to the MAX indication and put it back into the machine. 3) 2 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine without pod(s). 13) 3 Put a bowl (with a capacity of at least 1500 ml) under the coffee spout to collect the water (Fig. 4 Press on/off button 3 (1) and subsequently press the 1-cup button q and the 2-cup button qq briefly at the same time (2). 32) The machine fills itself with water from the water reservoir. While this happens, water comes out of the spout. When the flushing cycle is finished, the machine switches itself off. During the flushing cycle, the machine produces more noise than during a regular brewing cycle. Descaling Regular descaling will prolong the life of the coffee machine and will guarantee optimal brewing results for a long time. [. . . ] Make sure that the sieve in the centre of the pod holder is not clogged. If it is, unclog the sieve by holding the pod holder under a running tap. If necessary, you can use a washing-up brush or a pin to unclog the sieve. If problems continue to occur, contact the Philips Customer Care Centre in your country. the water reservoir has been properly placed; there is enough water in the water reservoir (i. e. [. . . ]