User manual PHILIPS HD7870

[. . . ] Com/senseo-twist/support 1 2 3 4 5 6 7 8 9 Introduction General description Important 5 5 6 6 9 13 14 17 17 17 17 18 Flushing the machine before first use Brewing SENSEO® coffee Cleaning Descaling Frost-free storage Ordering accessories 10 Environment 11 Guarantee and service 12 Troubleshooting 2 General description (Fig. 1) 1 Coffee collector 2 Lid lever 3 Lid with brewing chamber 4 Sealing ring 5 Water distribution disc 6 2-cup pod holder qq 7 1-cup pod holder q  8 Coffee spout cover 9 Coffee spout 10 Spout release buttons 11 Removable drip tray 12 Cup tray 13 Touch panel 14 On/off button 15 Personal coffee memory symbol (HD7872 only) 16 Regular coffee symbol 17 Selection button 18 Strong coffee symbol 19 CALC light 20 1-cup button q 21 2-cup button qq 22 Water reservoir 23 Water reservoir lid 5 1 Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Make your coffee moments truly special with SENSEO®. [. . . ] C Caution: Be careful not to damage the valve in the bottom of the water reservoir if you use a washing-up brush to clean the water reservoir. D Note: Check if the sieve in the centre of the pod holder is clogged. If this is the case, unclog the sieve by rinsing the pod holder under the tap. B Warning: Make sure the lid is closed properly and the lid lever is locked before you start descaling. The on/off button flashes slowly while the water heats up. The machine is ready for descaling when the on/ off button lights up continuously. 6 Put a bowl with a capacity of at least 1. 5 litres under the spout to collect the descaling mixture. 5L 15 E nglish Place the 1-cup pod holder q with a used coffee pod in it in the coffee machine. Close the lid and make sure it is properly locked. 7 When the on/off button lights up continuously, press the 1-cup button q and the 2-cup button qq at the same time for 3 seconds until you hear a beep. Release the buttons as soon as their lights as well as the selected strength go out. This means that the descaling procedure has been activated correctly. D Notes: Do not refill the water reservoir with used hot water or the used descaling mixture. 2 Tilt the water reservoir and place the bottom back onto the machine (1). Then press the top of the water reservoir towards the machine (2). €• The CALC light and the on/off button start flashing to indicate that the descaling cycle is in progress. €• During the descaling cycle, the water comes out of the machine in intervals. €• When all the water in the water reservoir has been used up, the descaling cycle is finished. The on/off button starts to flash rapidly. D Note: If you press the 1-cup and 2-cup button longer than 3 seconds, the machine does not start the descaling cycle. If this happens, press the 1-cup button and the 2-cup button at the same time for 3 seconds again. [. . . ] The coffee machine produces less coffee than before. The SENSEO® coffee is not strong enough. 20 Problem The coffee is not hot enough. Descale your SENSEO® coffee machine regularly. [. . . ]