User manual PHILIPS HD8010

[. . . ] Com/senseo-sarista/support User manual 1 English 4 Français 29 Nederlands 56 HD8030, HD8010 4 English Introduction Congratulations on your purchase of a Philips SENSEO® SARISTA beanfunnel coffeemaker and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. The Philips SENSEO® SARISTA bean-funnel coffeemaker uses a Douwe Egberts SENSEO® SARISTA bean-funnel to brew coffee from freshly ground beans, which ensures optimal aroma and taste. Douwe Egberts SENSEO® SARISTA bean-funnels are available in different varieties to suit different tastes. [. . . ] Lubrication For optimal performance of the coffeemaker, lubricate the brewing unit after 400 cups of coffee or once a month. -- For more information on what and how to lubricate, watch the instruction movies on www. -- For optimal brewing results, we advise you to use the lubricant by Philips. You can buy this lubricant in the online shop at www. 2 Follow steps 2 to 4 of section ‘Cleaning the brewing unit’ to remove the brewing unit from the coffeemaker. 3 Apply some lubricant to the guiding rails inside the brewing unit. 4 Apply some lubricant around the shaft in the bottom of the brewing unit. English 5 Apply some lubricant to the part shown in the figure. 19 6 Apply some lubricant on both sides of the lever in the brewing unit. 7 Follow steps 9 to 11 of ‘Cleaning the brewing unit’ to place the brewing unit and the coffee grounds container back into the coffeemaker. Adjusting the grinding degree Over time the grinder may change to a coarser setting. It is recommended to adjust the grinding degree when you notice this. These adjustments are not required regularly. 1 Take the grinding degree adjustment tool out of the recess next to the brewing unit. 2 Insert the lug on the broad end of the grinding degree next to the cap of the grinding degree adjustment hole and press lightly. 3 Insert the narrow end of the grinding degree adjustment tool into the grinding degree adjustment hole so that the opening in the tool fits onto the pin located at the bottom of the hole. 4 For a coarser setting, push down and turn the grinding degree adjustment tool clockwise. For a finer setting, push down and turn the grinding degree adjustment tool anticlockwise. Note:Turn the grinding degree adjustment tool one step clockwise or anticlockwise at the time. Then brew 2 or 3 cups of coffee to establish if the grinding degree has been adjusted to your satisfaction. 5 When you are satisfied with the grinding degree, remove the grinding degree adjustment tool from the grinding degree adjustment hole, close the cap and place the grinding degree adjustment tool back into its recess. 20 English Descaling the coffeemaker Scale builds up inside the coffeemaker during use. [. . . ] Use a moist cloth to clean the bottom of the coffee dispensing head. The coffeemaker stops brewing before the jug is filled. I cannot slide the brewing unit back into the coffeemaker. 28 English Possible solution Choose a bean-funnel with a stronger coffee blend. [. . . ]