User manual PHILIPS HD8323 ANNEXE 1

[. . . ] Português Español Français English Italiano Register your product and get support at 1 2 3 4 5 6 11 7 8 9 10 14 12 13 15 40 cm 16 in 16 17 18 20 cm 8 in 20 cm 8 in 20 cm 8 in 20 cm 8 in Fig. € 13 • Italiano 1 GENERAL INFORMATION 2 TECHNICAL SPECIFICATIONS The coffee machine is suitable for preparing 1 or 2 cups of espresso coffee and is provided with a swivel steam and hot water wand. The controls on the front side of the machine are labelled with easy-to-read symbols. The machine has been designed for domestic use and is not suitable for professional, continuous use. [. . . ] Wait until the "machine ready" light (18) turns on. The machine is now ready for coffee brewing. Accessories for coffee brewing are placed in a specially designed seat to make operations easy and immediate. If the ground coffee measuring scoop and/or the filters are required, lift lid cover (2) and take what you need (Fig. If coffee is NOT brewed after turning the selection knob (15) to the " " position, turn the selection knob (15) to the " " position and check the "Troubleshooting" table before removing the filter holder. 7) - Insert the filter (14) in the pressurized filter holder (12); the filter is already inserted when using the machine for the first time. 10) - Insert the filter holder into the brew unit (8) from the bottom. 11) - Turn the filter holder from left to right until it locks into place. Release the grip from the pressurized filter holder. The handle is automatically slightly turned leftwards. This movement guarantees proper pressurized filter holder performance. 13) - Preheat the pressurized filter holder by switching the selection knob (15) to the " " position until some water spills out of it (this is to be done only for the first coffee brewing). 14) -When 50cc of water have flowed out, set the selection knob (15) to the " " position to stop brewing. 16) - Remove the filter holder from the machine by turning it from right to left and pour out any water left. As the machine is fitted with the special filter (14), there is no need to change the filter to prepare either one or two coffees. 29) - Remove the measuring scoop from the machine. During coffee brewing, do not remove the filter holder (if inserted) by manually turning it clockwise. The filter holder can only be disconnected after bringing the selection knob (15) back to the " " position and cooling the machine down as described in section 4. € During this operation, the "machine ready" light (18) may flash; this is to be considered as a standard and not a faulty operating mode. Before using the machine, make sure that the hot water/ steam knob (3) is closed and that there is enough water in the machine tank. Press the ON/OFF button (11); the light (16) will turn on to indicate that the machine is on. Wait until the "machine ready" light (18) turns on. [. . . ] Fill the water tank and prime the circuit again (section 4. Coffee is not spilling out after turning the selection knob (15) Filter holder is clogged. Turn the selection knob (15) back to the " " position. Turn the machine off and let it cool down (approx. [. . . ]