User manual PHILIPS HD 8753

[. . . ] Register your product and get support at www. philips. com/welcome 02 Type HD8753 OPERATING INSTRUCTIONS 02 EN READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE. English IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. Close supervision is necessary when the appliance is used by or near children. Unplug from outlet when not in use and before cleaning. [. . . ] We recommend NOT to keep the container at room temperature for too long. Store the milk according to producer's instructions and do NOT use it after best-before date. Wash the container as described in the "MILK CARAFE CLEANING" section (see page 31). Emptying the Milk Carafe The operations illustrate how to empty the milk contained inside the carafe. 1 Press the release buttons to allow the lid removal. 2 Lift the lid; now the milk contained inside may be emptied. ENGLISH 23 Cappuccino The following steps describe how to prepare a cappuccino. Dispensing may be preceded by short sprays of milk and steam. Wait for the end of the cycle before removing the container. Refer to the section "Milk Carafe". 1 Fill the milk carafe with the desired quantity. Note: To ensure better results when preparing a cappuccino, use cold milk. 2 Open the milk dispenser and insert the milk carafe into the machine. 3 Place the cup for the cappuccino under the carafe dispenser. Note: Ensure that the cup is positioned correctly under the dispenser to avoid spilling the product. Note: It is possible to prepare a cappuccino with pre-ground coffee as well. Select the function with the “ ” button and pour the coffee in the compartment as described in the proper section. 4 Press the “ right away. ” button; the machine starts preparing the cappuccino Note: Wait for the cycle to end before removing the container. Yellow 5 The following icon is displayed during the preheating time required by the machine. 6 When the following icon is displayed, the machine dispenses frothed Green milk directly in the cup. 7 The machine pours a predefined quantity of frothed milk into the cup. The pouring may be stopped early by pressing the “ ” button. 24 ENGLISH 8 Once the milk has been poured, the machine starts brewing the coffee. Green 9 The machine pours a predefined quantity of coffee into the cup. The pouring may be stopped early by pressing the “ ” button. After using the milk carafe to prepare the desired number of cappuccino cups, wash it as described in the "Cleaning and Maintenance" chapter. Adjusting the Cappuccino Length (MEMO Function) The machine allows you to adjust the amount of cappuccino brewed according to your taste and/or the size of your cups. Each time the “ ” button is pressed and released, the machine pours a pre-set amount of cappuccino. This amount may be set again according to your taste. 1 Prepare the machine to brew a cappuccino. 2 Place the desired cup under the dispensing spout. 3 Press and hold the " " button until the "MEMO" icon is displayed and remove your finger. The machine is now programming. Yellow 4 The following icon is displayed during the preheating time required by the machine. 5 The machine begins dispensing the milk. The display shows the “STOP” Green symbol. ” button when the desired amount of milk is reached in ENGLISH 25 6 Once the milk dispensing procedure is complete, the machine begins Green the coffee brewing phase. The “STOP” message is displayed. ” button when the desired amount of coffee is reached in " button has been programmed; each time it is pressed and Now the " released, the machine will brew the same amount that has just been set. Hot Milk The following steps describe how to prepare hot milk. Dispensing may be preceded by short sprays of milk and steam. Wait for the end of the cycle before removing the container. Refer to the section "Milk Carafe". 1 Fill the carafe with the desired quantity of milk. Note: To ensure better results when preparing a hot milk, use cold milk. 2 Open the milk dispenser and insert the milk carafe into the machine. 3 Place the cup for hot milk under the carafe dispenser. Note: Ensure that the cup is positioned correctly under the dispenser to avoid spilling the product. Green 4 Press the " 5 Press the “ " button. ” button to start hot milk dispensing. Note: Wait for the cycle to end before removing the container. 6 The following icon is displayed during the preheating time required by Yellow the machine. 7 The machine pours a preset quantity of hot milk into the cup. The Green pouring may be stopped early by pressing the “ ” button. After using the milk carafe to prepare the desired milk, wash it as described in the "Cleaning and Maintenance" chapter. 26 ENGLISH Adjusting the Amount of Hot Milk in the Cup (MEMO Function) The machine allows you to adjust the amount of dispensed hot milk according to your taste and/or the size of your cups. [. . . ] Clean the Brew Group ("Brew Group" section). Clean the dispensing spout and its holes. Note: These problems can be considered normal if the coffee blend has been changed or the machine is being installed for the first time. In this case wait until the machine performs a self-adjusting operation as described in section "Saeco Adapting System". Please, contact our consumer care help line at the phone number listed at the last page of this document for any problems not covered in the above table or when the suggested solutions do not solve the problem. Technical Specifications The manufacturer reserves the right to make changes to the technical specifications of the product. Nominal voltage - Power rating - Power supply . [. . . ]