User manual PHILIPS HF3485

[. . . ] Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. The Philips Wake-up Light helps you wake up more pleasantly. The light intensity of the lamp gradually increases to the set level in the set sunrise simulation time (the default time is 30 minutes). [. . . ] 2 Follow instructions 1-4 in section `Menu functions' above to select music from a USB stick as alarm sound. , The display shows 0001 to indicate the first song on the USB stick. , The selected song is now set as the alarm sound. Setting the sunrise simulation time The sunrise simulation time is the time in which the light intensity of the lamp gradually increases to the set level before the alarm sound is played. The default sunrise simulation time is 30 minutes, because this is the optimum time for your body to prepare for waking up. As the sensitivity to light differs from person to person, it is possible to adjust the sunrise simulation to your own preference. you can reduce the sunrise simulation time to 20 or 25 minutes or increase it to 40 minutes. 1 Simultanuously press and hold the light intensity increase and decrease buttons for 3 seconds (Fig. Snoozing 1 Tap on the surface of the Wake-Up light with the inside of your hand to snooze the appliance (some force needs to be applied to prevent accidental snoozing) (Fig. , The lamp continues to be on at the selected intensity level, but the alarm sound stops. After 9 minutes, the alarm sound is automatically played again. note:The 9-minute snooze time is fixed. Switching the alarm function off and on 1 To switch off the alarm function when the alarm goes off, push down the control lever to the bottom position (Fig. Note:The songs are ordered based on the date that the music was put on the USB stick. If you want the songs to be played in a specific order, put them in this order on your computer first and then copy them to your USB stick. Setting the volume 1 To set the volume for the radio or music from a USB stick, press the volume increase or decrease button. 32) You can choose a volume level between 1 and 20. Note:The volume level you have selected is automatically set as the volume level for the alarm as well. Sunset simulation You can use the sunset simulation when you want the light and/or the sound of the Wake-up Light to stay on and dim gradually during a set period of time (15 minutes to 1. The lamp and/or sound switch off automatically after the set time. Note:The light intensity you set for the start of the sunset simulation is also used as the light intensity for the sunrise simulation See sections `Using the appliance as a bedside lamp' and/or `Using the radio/playing music from a USB stick' in this chapter. 2 Follow the steps in section `Menu functions' in this chapter to select the sunset simulation function and to set the sunset simulation time. [. . . ] If you want to snooze, you the alarm did not go have to tap on the appliance. The light wakes me too Perhaps the light intensity level you have set is not appropriate for you. Try a lower light intensity level if you wake up too early. If light intensity 1 is not low enough, move the appliance further away from the bed. [. . . ]