User manual PHILIPS HF3490

[. . . ] Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. The Philips Wake-up Light helps you wake up more pleasantly. The light intensity of the lamp gradually increases to the set level in the 30 minutes before the set wake-up time. [. . . ] 2 Move the middle function selector (SET) up or down to select the hour. Note:You can only do this when the hour indication flashes. If this is not the case, push the control lever up and down again to enter the alarm time mode. you can also set the alarm time in the menu. See section `Menu functions of middle function selector (SET)' in this chapter. 4 Move the middle function selector (SET) up or down to select the minutes. , The appliance leaves the menu and the display shows the clock time. Switching off the alarm To switch off the alarm function, push up the control lever to the top position. note:The alarm (sound and/or light) automatically switches off after 90 minutes. Setting the alarm sound See section `Menu functions of middle function selector (SET)' above. You can choose one of the following sounds: - Music from your iPod/iPhone (see section `Using your iPpod/iPhone as alarm sound' below) (Fig. 19) using your ippod/iphone as alarm sound 1 Select a wake-up song (or album/playlist) on your iPod/iPhone. You can switch off the lamp by pressing the top function selector. , When you have selected your iPod/iPhone as alarm sound, the paused song starts playing at the set alarm time. Note: If the iPod/iPhone is unable to play the selected song, you hear the bird alarm sound of the Wakeup Light at the set alarm time 1 Push down the control lever to the bottom position when the alarm goes off. 20) , The lamp continues to be on at the selected intensity level, but the alarm sound stops. After 9 minutes, the wake-up sound is automatically played again. note:The 9-minute snooze time is fixed. Note: If you push down the control lever with too much force, it may jump back to off position. Alarm demonstration If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and sound level, activate the test function of the appliance. 1 Push the control lever down to the bottom position for a few seconds until TEST appears on the display (Fig. Note:The appliance continues to run the alarm demonstration until you push down the control lever again. [. . . ] Perhaps you did not place the iPod/iPhone properly in the iPod/iPhone station. Make sure you place the iPod/iPhone correctly in the iPod/ iPhone station. see chapter `Using the appliance' , section `Using the iPod/iPhone'. Perhaps you had not placed the Wake-up Light properly on the base. [. . . ]