User manual PHILIPS HF8400

[. . . ] regularly check the massagers , the charging case and the adapters for possible damage. If any of these items is damaged in any way, stop using it and consult our website www. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. These massagers are not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the massagers by a person responsible for their safety. [. . . ] Using the appliance Note:The massager shown in the figures is the female massager. the male massager has the same buttons and functionalities. Thoroughly clean the massagers before first use, after every use and when you use them on another body area, to reduce the risk of infection (see chapter `Cleaning'). You can gradually increase the vibration speed once you are familiar with the options. Note: If you feel uncomfortable during use, you can adjust the vibration speed. The massager has 4 vibration modes: 1 continuous vibration, 2 a pattern of pulses that rises and falls in intensity 3 a gentle, relaxing pulse 4 a more intense pulse Press the increase or decrease button one or more times to adjust the vibration speed to your own preference. You can hold the massager in different ways. Experiment to find the most comfortable way to use the massager. tip: For suggestions , consult the welcome booklet. Tip:You can also use the massager in combination with a water-based or silicone-based lubricant or massage oil. Do not use scented and/or alcoholbased lubricants or massage oils, as they may cause damage. 5 To switch off the massager , press and hold the mode selection button or the decrease button. Travel lock It is possible to lock the massager, for example if you are going to travel. The travel lock prevents the massager from being switched on by accident. 7) , The light ring flashes once to indicate that the massager is locked. , The light ring flashes once to indicate that the massager is unlocked. Note:When you place the locked massager in the plugged-in charging case and close the lid, the travel lock is automatically deactivated. Cleaning Thoroughly clean the massagers before first use, after every use and when you use them on another body area, to reduce the risk of infection. do not use aggressive or abrasive cleaning agents , chemical substances or alcohol-based disinfectants to prevent damage to the massagers. Do not clean the massagers with materials or tools that could cause damage, e. Never immerse the massagers and the charging case in water or any other liquid, nor rinse them under the tap. Clean the massagers with a moist cloth soaked in lukewarm water with mild anti-bacterial soap. [. . . ] If you are unable to solve the problem with the information below, consult our website wwww. Solution It takes 24 hours to charge the massagers fully. when fully charged , the massagers have an operating time of up to 1 hour. For a single session, charge the massagers for at least 10 hours (see chapter `Charging'). [. . . ]