User manual PHILIPS HF-8420

[. . . ] 4 Close supervision is necessary when this appliance is used by, on, or near children, invalids or disabled persons. 5 Use this appliance only for its intended household use as described in this manual. Do not use attachments not recommended by Philips Electronics North America Corporation. 6 Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped, damaged or dropped into water. [. . . ] Note:When you unpack the massager, the battery usually contains enough energy for a `quickie'. In some cases, however, the battery may be empty due to environmental conditions. It takes about 4 hours to fully charge the massager. A full charge gives you and your partner up to 5 hours to explore each other. The actual operating time may vary over time, depending on the selected vibration mode and speed level. Charge the massager when the light rings start flashing slowly to indicate that the battery is almost empty. 1 Make sure that all parts (massager and charger) are dry. 2 Insert the small plug into the charger and put the adaptor in the wall socket. It only fits properly on the charger with the moulded surface facing up and the buttons on the side. The massager switches off automatically when you place it on the charger. , The massager slowly vibrates for a few seconds to get into the correct position for optimal charging. Note:The charger does not work when the massager is placed incorrectly on the charger. , The charging light on the charger starts flashing to indicate that the massager is being charged. Note:When you charge the massager for the first time or after a long period of non-use, it may take a few minutes before the light rings start flashing. Note:The appliance may produce a smell the first few times you charge it. Using the appliance Use this appliance for its intended household use as described in this manual. Thoroughly clean the massager before first use, after every use and when you use it on another body area, to reduce the risk of infection (see chapter `Cleaning'). 1 Press any button to switch on the massager. Note: If the massager has not been used for more than 7 days, you can only switch it on by pressing the + button. Tip:You can adjust the speed and select a mode you like once you have familiarized yourself with the options available. 2 Press the mode selection button to adjust the vibration to your own preference. The massager has 4 vibration modes: 1 Glow ­ the massager vibrates in a steady, continuous way 2 Wave ­ a slow, relaxing pattern of pulses that rises and falls in intensity 3 Heart beat ­ a steady pulse, like a rapidly beating heart 4 Thrill ­ a more intense, exciting pattern of pulses that rise and fall in intensity 3 Press the increase or decrease button one or more times to adjust the vibration speed of the massager to your own preference. [. . . ] Let the appliance cool down to room temperature before you continue using it. Insert the small plug into the charger and put the adaptor in the wall outlet. You have not placed the massager on the charger properly. The massager and its charger become warm during charging. [. . . ]