User manual PHILIPS HI558

[. . . ] This (harmless) phenomenon will cease after a short while. ⷠDo not put vinegar or other descaling agents into the water reservoir. The cordset should not be allowed to touch the soleplate when it is hot. ⷠRegularly check if the mains cord is still in a good and safe condition. [. . . ] - When the amber pilot light (H) has gone out and has come on again you can start HI 568/69 ironing. ⷠThe amber pilot light (H) will come on from time to time during corded ironing. ⷠIf you set the temperature control to a lower Setting after ironing at a high temperature, do not recommence ironing before the amber pilot light (H) first has come on and then has gone out again. At any temperature by pushing on the spray button T (C) a couple of times the laundry can be damped down (fig. Ensure that there is enough water in the water reservoir. steam-ironing · As indicated on the temperature control (A) and the table, steam-ironing is only possible at higher ironing temperatures: 2 or 3 for moderate steam 3 for maximum steam. ⷠWith conventional steam irons, water may leak from the soleplate if a too low temperature has been selected. However, your new steam iron features "Drip Stop" steam shut-off: the iron will automatically stop steaming at too low temperatures. When this happens, you can hear "Click". Ensure that there is enough water in the water reservoir. - Insert the mains plug 21 into the wall socket. - After the amber temperature pilot light (H) first has gone out and has come on again, you may start ironing. - Take the iron (with power unit) from the stand (fig. - Either place iron (with power unit) on heel rest or on the stand when you interrupt ironing. - Take the iron (without power unit) from the stand (fig. (Types HI 565/66 only) The user may continue ironing as long as there is no lamp indication. However, if the pilot light (H) starts to flash, it indicates that the iron has cooled down below the set temperature. for optimal ironing performance the iron should be replaced to the stand for heating up to the set temperature. As soon as the soleplate has regained the set temperature, the pilot light (H) wil go out. ⷠWhen cordless steam-ironing for a considerable time and when applying a number of "shots of steam" or "turbo steam" the soleplate might cool down more than required. For that reason we advise you to always use the iron in the corded mode if you intend to 7 The extra steam works as long as the Turbo steam button 0 (F) is kept pressed-in. Do not keep the button pressed-in for more than 10 seconds without interruption. [. . . ] - The upper part of the appliance can be cleaned with a damp cloth. - From time to time clean the inside of the water reservoir by filling with water and shaking. - Remove the mains plug from the wall socket. The iron, the power unit and the stand are then locked together. [. . . ]